1) in Labor
临产
1.
Objective:To explore the relation between the expression of blood plasma, cervical secretion FFN and spontaneous parturition, and to provide objective, practical and early operational test methods for the clinical prediction of spontaneous time in labor.
目的 :探讨血浆、宫颈分泌物胎儿纤维结合素 (FFN)的表达与自然临产的关系 ,为临床预测自然临床时间提供客观、实用、易操作的检测方法。
2.
Methods: The lower uterine segment tissue specimens were obtained from 15 cases with term in labor( I ), 15 cases with term before labor( II), 15 cases with preterm in labor (III) and 15 cases with preterm before labor(IV).
方法：分足月临产组(Ⅰ)、足月未临产组(Ⅱ)、早产临产组(Ⅲ)及无先兆早产组(Ⅳ)，每组15例。
2) Preterm labor
早产临产
1.
Methods A total of 81 women with spontaneous preterm labor(sPTL) and 51 with cervical incompetence(CI) before their 34th gestational weeks were enrolled in this study from January 2003 to March 2006.
方法选择2003年1月至2006年3月北京大学第三医院的34周前的早产临产及宫颈机能不全患者,早产临产患者采取紧急宫颈环扎术联合宫缩抑制剂或者单纯使用宫缩抑制剂治疗。
3) parturient
[英][pɑ:'tjuəriənt] [美][pɑr'tjʊrɪənt]
①临产的 ②产妇
4) Critical output
临界产量
1.
Through analyzing the effect of the vertical locations of horizontal wells on the critical output and gas breakthrough time of the gas cap reservoir, the curve showing the relationship between the vertical locations of horizontal wells and the critical output as well as the gas breakthrough time is obtained in t.
针对这一问题,从水平井垂向位置对气顶油藏临界产量和见气时间的影响入手,得出了临界产量和见气时间与水平井垂向位置的关系曲线;在综合考虑临界产量和见气时间的基础上,得到了水平井垂向位置与临界产量和见气时间乘积的关系曲线,由曲线趋势得到了气顶油藏水平井最优垂向位置的范围。
2.
The bottom water coning model used by Boyun Guo considered the influence of perforation length on critical output, so it can be used to calculate the perforation length of bottom water reservoir.
由于BoyunGuo等人使用的底水锥进模型引入了射孔长度对临界产量的影响,所以可用于优化底水油藏的射孔段长度。
3.
The paper has discussed the effect of vertical locations of horizontal wells on the critical output and producing pure oil time,analyzed the ratio .
水平井垂向位置与临界产量、产纯油时间、油水密度差和油气密度差比值,以及临界产量与产纯油时间的乘积等关系的研究结果表明,水平井垂向位置越靠近气顶或底水,临界产量越高,但产纯油时间越短;越靠近最佳位置(气水同时锥进到油井中),临界产量越低,产纯油时间越长。
5) critical production rate
临界产量
1.
Calculation method of critical production rate for fractured-vuggy reservoir with bottom water
塔河油田缝洞型底水油藏临界产量计算研究
2.
In 1993, a formula for critical production rate of oil well in bottom water reservoir with partition board was proposed by Dr.
1993年李传亮提出的带隔板底水油藏油井临界产量的计算公式中不含油井打开程度的参数,即没有考虑油井打开厚度的影响。
3.
On the basis of this theoretic model, the critical production rate, the shape of water coning and the optimum perforation intervals could .
在理论模型的基础上,建立了预测临界产量、水锥形态以及优化射孔长度的数学模型。
6) critical production
临界产量
1.
The research and application of critical production model of fractures sand entry in fracturing gas well;
气井裂缝出砂临界产量模型研究及应用
2.
Then, the factors affecting production, critical production and water breakthrough time is studied an.
利用镜像反映及势函数的叠加原理 ,在获得底水油藏中任意一点的势函数后 ,得到了底水油藏中水平井底势差和水平井的产量方程 ,由此研究影响水平井产量、临界产量及见水时间的因素 ,通过研究获得了底水油藏中水平井的合理位置 ,为水平井开采底水油藏的优化设计提供了理论基
3.
In order to determine the suitable commissioning production, the critical production of bottom water coning must be studied.
QHD32 - 6油田A2 6水平井油层下有一底水 ,为了确定合理的投产产量 ,需要确定底水锥进的临界产量值。
补充资料：临产
临产
临产指的是分娩活动开始。其标志为有规律的逐渐增强的子宫收缩，持续30秒或以上，间隔5～6分钟，同时伴随进行性宫颈管消失，宫口扩张和胎先露部下降。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条