1) room tensile strength
室温抗张强度
1.
The room tensile strength of the filament exhibitsa normal distribution.
测定了 SiC(W 芯)纤维的抗张强度,实验表明:对用 CVD 法制备的 SiC(W 芯)纤维的抗张强度测试值随试样标距的增大而降低,其室温抗张强度呈正态分布状态。
2) Room temperature bending strength
室温抗弯强度
3) compressive strength at room temperature
室温抗压强度
1.
The bulk density,compressive strength at room temperature,thermal shock resistance and load-deformation under high temperature of SiC-based ceramic foam filters were measured and contrasted among the products of Foseco(UK) and three Chinese companies.
测量并比较了铸造用碳化硅质泡沫陶瓷过滤器英国Foseco产品和国内三种产品的容重、室温抗压强度、抗热震性和高温负荷变形等。
4) long-time high temperature tensile strength
持久高温抗拉强度，持久高温抗张强度
5) tensile strength
抗张强度
1.
The results showed that rock tensile strength of sample with a diameter of 25 mm and a length of 25mm treated by drilling fluid was higher than that of untreated rock samples with a diameter of 50mm and a length of 50mm.
在考虑试验岩样尺度效应的基础上,进行的模拟地层条件下钻井液对岩石力学性质影响的试验研究结果表明:经钻井液处理后的25mm×25mm岩样的抗张强度高于未经钻井液处理的50mm×50mm岩样,且处理后的岩样抗张强度均高于未处理的岩样。
2.
The improvements of packaging paper strengths,including stiffness,ring crush compression resistance,folding endurance and tensile strength,by novel strengthening agents was investigated.
该文探讨了用新型增强剂提高纸页的包装强度:挺度、环压强度、耐折度、抗张强度;比较了几种增强剂对提高纸页包装强度的效果,确定了最合适的增强剂及用量,并研究了最合适的增强剂对不同纸浆、不同定量纸页包装强度的影响,确定采用4号增强剂且用量为0。
3.
The results showed that the brightness of the hand-sheets decreased with increasing dosage of SDS;and the tensile strength of hand-sheets increased first with increasing charge of SDS,then decreased;however,the tearing strength of the hand-sheets decreased first with the increasing dosage of SDS and then increased;the air permeability of the hand-sheets reached maximum at a certain dosa.
研究表明,纸页的白度随非离子瓜尔胶浓度的增加而降低;抗张强度先随非离子瓜尔胶添加量的增大而增大其后随之下降;撕裂度先随非离子瓜尔胶用量的升高而下降其后随之提高;透气度先随非离子瓜尔胶用量的升高而增加达到一个峰值后又降低。
6) strength at room temperature
室温强度
1.
When solid solution temperature exceeds 1 100 ℃,the grade of grain size and the strength at room temperature decreases with the increasing of solid solution temperature.
试验结果表明,随固溶温度升高,晶间腐蚀敏感性下降,为抑制晶间腐蚀,固溶温度应≥1100℃;钢管固溶后应快速冷却,以避免840℃附近Cr23C6碳化物大量析出导致敏化;固溶温度超过1100℃,随固溶温度升高,晶粒度等级和室温强度逐渐下降。
补充资料：Z向抗张强度
分子式：
CAS号：
性质：纸产品属于三度结构材料，除了纵、横向强度之外，垂直于纸平面的强度也很重要。内结合强度系指在特定条件下，使单位面积的纸或纸板发生内部脱层所需要的力，以N/cm2表示。也称Z-向抗张强度。内结合强度主要决定于纤维间结合强度，受纤维长度和纤维本身强度的影响小，但受打浆、抄纸、湿压榨、造纸添加剂和纸页中细小纤维含量等的影响很大。
CAS号：
性质：纸产品属于三度结构材料，除了纵、横向强度之外，垂直于纸平面的强度也很重要。内结合强度系指在特定条件下，使单位面积的纸或纸板发生内部脱层所需要的力，以N/cm2表示。也称Z-向抗张强度。内结合强度主要决定于纤维间结合强度，受纤维长度和纤维本身强度的影响小，但受打浆、抄纸、湿压榨、造纸添加剂和纸页中细小纤维含量等的影响很大。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条