1) phase configuration
相组态结构
2) morphological structure
相态结构
1.
Effects of coupling agents on curing characteristics and physical-mechanical properties of the two kinds of composites were investigated,and the morphological structure of the composites were observed by scanning(electron) microscope.
采用乳液共混法制备了淀粉/丁苯橡胶(SBR)以及间苯二酚甲醛树脂(RF)改性淀粉/SBR复合材料,考察了偶联剂对2种复合材料硫化特性、力学性能的影响,并用扫描电镜观察了其相态结构。
2.
The morphological structure of dynamically vulcanized thermoplastic(elastomer)(TPV) ethylene propylene diene monomer(EPDM)/polypropylene(PP) was investigated with scanning electron microscope.
用扫描电镜研究了三元乙丙橡胶(EPDM)聚/丙烯(PP)动态硫化热塑性弹性体(TPV)相态结构的形成过程,探讨了交联密度、制备工艺、螺杆转速对EPDM/PP TPV相态结构的影响。
3.
The morphological structures of NBR/PP TPV were analyzed.
苄酯4种增塑剂对丁腈橡胶(NBR)聚/丙烯(PP)热塑性硫化胶(TPV)邵尔A硬度、耐油性能和流变性能的影响,并用透射电镜分析了4种增塑剂对NBR/PP TPV相态结构的影响。
3) Phase Structure
相态结构
1.
Study on microstructure and phase structure of SBS modified asphalt;
SBS改性沥青显微结构及相态结构研究
2.
The phase structure analysis on CPVC/CR-MMA graft modificated adhesives;
CPVC对CR/MMA体系接枝的相态结构分析
3.
On the basis of morphologies obtained by the scanning electron microscope(SEM),mechanical properties and absorption ratio test results,it has been shown that the phase structure of the blend that has undergone γ-ray irradiation is different from the un-irradiat.
扫描电镜(SEM)观察结果表明,γ射线辐照会影响共混物的相态结构;辐照4 h后,共混物样品的吸收剂量为15。
4) morphology
[英][mɔ:'fɔlədʒi] [美][mɔr'fɑlədʒɪ]
相态结构
1.
Mechanical properties, crystal and morphology properties of composites were examined.
用广角X射线衍射仪对聚丙烯的结晶状况进行了表征,计算了复合材料中聚丙烯的结晶度;用扫描电镜观察了样条的断口形貌,讨论了滑石粉填充量对材料结晶性能与相态结构的影响,以及PP相结晶度和体系的微相结构对复合材料的拉伸、弯曲及冲击性能的影响。
2.
In this paper development of polymer/clay nanocomposite in recent years based on microstructure of nanocomposites morphology,intercalation,exfoliation and crystallinty behavior etc were reviewed with 31 ref
从聚合物/粘土纳米复合材料的相态结构、影响粘土插层解离和聚合物结晶行为的因素等方面对聚合物/粘土纳米复合材料的研究近况进行了综述。
3.
The effect of IR/CR blends by adding small amount of styrenic thermoplastic elastomer(less than 10% mass)on the morphology,network and mechanical properties was studied by optical microscopy and Moony-Rivlin equation.
采用相差显微镜及Moony-Rivlin方程中的2C1和2C2等方法,研究了少量SIS,SBS,α-甲基苯乙烯和丁二烯的三嵌段共聚物(MSBMS)对IR/CR共混物相态结构、交联行为和力学性能的影响。
5) morphological texture
相态结构
1.
The morphological textures and mechanical properties of PP/PA-6 alloy have been studied in this paper.
通过对PP/PA-6合金的相态结构及力学性能的研究,发现PP/PA-6合金的相态结构与是否加入相容剂有关,屈服强度是合金中PA-6的体积含量的函数,缺口冲击强度主要取决于分散相颗粒表面间距,并且可以用经验公式描述。
6) morphology structure
相态结构
1.
Effect of the amount of DCP on the mechanical properties,crystal structure of PP and morphology structure of POE of POE/PP by dynamic vulcanizing were investiga- ted.
而结晶度下降;DCP对相态结构影响显著,用量为1份时交联POE以较小的颗粒均匀分布于PP连续相中。
补充资料:电子组态
电子组态 electron configuration 原子内电子壳层排布的标示。又称电子构型。原子中的电子排布组成一定的壳层,例如 ,硅原子的电子组态是 1s22s22p63s23p2,表示其14个电子中2个排布在1s态,2个排布在2s态,6个排布在2p态,2个排布在3s态和最后 2 个电子排布在3p态,有时可简示为 3s23p2如果一个电子激发到4s态,则相应的电子组态为1s22s22p63s23p4s。或简示为3s23p4s。电子组态清楚地显示出核外电子的排布状况。 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条