1) VAC-grafted SBR
VAC接枝SBR
2) SBR process
SBR
1.
According to the quantity and quality variation of tannery wastewater mixed with printing and dyeing wastewater,a wastewater treatment modification technology based on PAC-SBR process was put forward.
针对制革废水混入印染废水后水量、水质的变化情况,提出以粉末活性炭(PAC)—SBR为核心的废水处理改造工艺,重点分析了改造思路以及各处理单元的具体改造情况。
2.
Under deficient source water alkalinity,the capabilities and the procedure of the alternating aerobic/anoxic SBR process for nitrogen removal were studied.
当原水碱度不足时,针对SBR工艺,采用好氧/缺氧循环的运行方式进行脱氮性能及其过程控制的研究。
3.
In this paper, SBR process and PACT process were used to treat pulping wastewater.
通过将SBR工艺和PACT工艺分别用于处理造纸废水,试验结果表明,在相同的条件下(如容积负荷、水力停留时间等),PACT工艺具有CODCr去除率较高、对主要环境因素的变化(如pH值等)的适应能力较强、工作稳定性较高、活性污泥的性状更优越等优势。
3) Sequencing batch reactor
SBR
1.
The preliminary study of the manipulation of the operational timing period in the sequencing batch reactor technologies treatmenting waste water;
废水处理中SBR工艺运行时间周期的控制
2.
Study on Kinetics of Organic Degradation in Sequencing Batch Reactor (SBR);
SBR法有机物降解动力学研究
3.
Factors Affecting Simultaneous Nitrification and Denitrification in Sequencing Batch Reactor;
SBR反应器中同步硝化反硝化影响因素研究
4) Sequencing Batch Reactor(SBR)
SBR
1.
When digested piggery wastewater was directly treated with a sequencing batch reactor(SBR) process,the efficiency was low with COD removal about 10% and NH~+_4-N removal about 70%.
采用序批式反应器(SBR)工艺直接处理猪场废水厌氧消化液,处理系统的效率较低,COD去除率仅有10%左右,NH4+-N去除率70%左右;处理出水水质较差,出水COD高于1 000mg/L,出水NH4+-N在200mg/L左右;处理系统的工作不稳定,效能逐渐恶化。
2.
Hydrodynamic turbulence conditions were changed by adjustment of stirring paddle in sequencing batch reactor(SBR).
为优化活性污泥处理系统的设计和运行,在SBR反应器中通过改变搅拌浆的转速,调整水流的紊动条件,借助粒子图像测速技术分析了反应器内水流的紊动特性,研究了反应器内不同区域紊动强度对活性污泥沉降性能的影响。
3.
The two-stage sequencing batch reactor(SBR) and single-stage sequencing batch biofilm reactor(SBBR) were used to treat this wastewater.
针对榨菜综合废水呈高盐、高氮磷、高有机物浓度的水质特征,对两级SBR与单级SBBR反应器处理榨菜废水的效能进行了研究。
5) anaerobic/anoxic-SBR
A/A-SBR
6) Grafting
[英][grɑ:ft] [美][græft]
接枝
1.
Studies on the technique of solid grafting polypropylene with dual monomers;
双单体固相接枝聚丙烯技术研究
2.
Study on Surface Grafting of Nano-meter TiO_2 by PMA and its UV Aging Resistance in PP;
PMA表面接枝包覆纳米TiO_2及其在PP中抗紫外老化的研究
3.
Study on starch grafting copolymerization to prepare the flocculating agent with CAN-KPS initiation system;
CAN-KPS体系引发淀粉接枝共聚为絮凝剂的工艺研究
补充资料：表面接枝
分子式：
CAS号：
性质：液相单体在固态聚合物表面上进行的非均相接枝反应。用于聚合物膜、纤维及其他聚合物材料表面的改性。引发接枝的方法有：在固体聚合物表面含有还原性基团时，在氧化性引发剂存在下经氧化还原引发；辐照引发；等离子体引发等。用于天然及合成高聚物的改性，如纤维素纤维、淀粉、羊毛和蚕丝等的接枝改性。
CAS号：
性质：液相单体在固态聚合物表面上进行的非均相接枝反应。用于聚合物膜、纤维及其他聚合物材料表面的改性。引发接枝的方法有：在固体聚合物表面含有还原性基团时，在氧化性引发剂存在下经氧化还原引发；辐照引发；等离子体引发等。用于天然及合成高聚物的改性，如纤维素纤维、淀粉、羊毛和蚕丝等的接枝改性。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条