1) impact rate
冲击速率
1.
Tests of charpy impact of different impact ratio of 93W-Ni-Fe liquid-phase sintering alloy-tungsten at different technological state show the macroscopic law that impact rate from 5 to 40m/s is increased as impact toughness of alloytungsten rises.
通过对不同工艺状态下的93W-Ni-Fe液相烧结钨合金的不同冲击速率的夏比冲击试验,得出了钨合金材料5～40m/s范围冲击韧性随冲击速率提高而增加的宏观规律,同时,通过冲击试样断口的扫描电镜分析,对钨合金材料高速冲击下断裂的微观机制有了进一步的认识。
2) attack rate
发病率;冲击速度
3) rate equation/shock initiation
速率方程/冲击起爆
4) low-velocity impact
低速冲击
1.
Computer simulation of low-velocity impact process of the composite laminate with defect;
含缺陷的复合材料层合板低速冲击过程的有限元模拟
2.
To analyze the response of composite laminated plate under low-velocity impact,a finite element analysis model is established.
针对低速冲击作用下的复合材料层合板,采用冲击接触定律、失效准则和材料性能退化技术,建立了冲击的三维有限元模型。
3.
In this paper, using dynamic finite element method based on 3D nonconforming layered element, alow-velocity impact finite element analysis of 2D mixed woven composite laminates is performed.
将二维机织碳布和单向碳布预浸料按照一定比例铺设成的混合机织复合材料兼具比刚度、比强度高、抗低速冲击损伤以及工艺性好等优点。
5) low velocity impact
低速冲击
1.
Local deformation rigidity of reinforced concrete beam under low velocity impact;
低速冲击下钢筋混凝土梁局部变形刚度
2.
Response of SMA reinforced composite beam to low velocity impact;
SMA增强复合材料梁的低速冲击响应分析
3.
Tensile properties of plane woven composite laminates after low velocity impact;
平面编织复合材料层合板低速冲击后的拉伸性能
6) high-velocity impact
高速冲击
1.
By using optical microscope and SEM,the change in structure and the fracture morphology of a bainitic ductile iron under high-velocity impact were investi-gated.
使用光学显微镜和扫描电子显微镜研究了贝氏体球铁高速冲击下的组织变化和断口形貌。
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条