1) Precooling quenching after forging
锻热预冷淬火
2) forged harding
锻热淬火
1.
The structure of the forged harding Cr12MoV steel has been studied with metallographical examination and electron microscopy test in this paper.
对Ｃｒ１２ＭｏＶ钢锻热淬火的组织进行金相分析和电子显微分析。
3) delay quenching
预冷淬火
1.
Based on that hardened case depth can be increased by delay in air after forging,the technique of delay quenching after forging is proposed in this paper.
基于锻后预冷淬火可提高工件的淬硬层深度，本文提出锻后余热预冷淬火工艺。
4) preheating quenching
预热淬火
5) remnant forging thermal quenching
锻造余热淬火
1.
The technology of remnant forging thermal quenching for the automotive axle tube was investigated by means of measurements of mechanical properties and observation on metallurgical microstructure.
通过力学性能和金相组织观察,研究了汽车轮毂轴管锻造余热淬火工艺。
6) quenching directly after forging
锻件余热淬火
补充资料：α型钛合金热锻缓冷组织
α型钛合金热锻缓冷组织
719
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条