1) limit soluble
端际固溶度
3) solution temperature
固溶温度
1.
Effect of solid solution temperatures on the mechanical properties and microstructure of sand-cast samples of ZL210A cast aluminum alloy;
固溶温度对ZL210A铸造铝合金砂型试样力学性能和微观组织的影响
2.
Effects of solution temperature on precipitation of β-Mg_(17)Al_(12) phase and mechanical properties of AZ80 magnesium alloy;
固溶温度对AZ80镁合金析出相β-Mg_(17)Al_(12)及性能的影响
3.
Influence of solution temperature on microstructure and toughness of weld joint in 2205 duplex stainless steel
固溶温度对2205双相不锈钢焊缝组织与韧性的影响
4) solid solubility
固溶度
1.
Solid Solubility Metastable Extension of Rare Earht Metals in Gold;
稀土元素在金中固溶度亚稳扩展研究
2.
Determination of the solid solubility of Fe_(2+x)Ti_(1-x)Sn_y by the lattice parameter method
点阵参数法测定Fe_(2+x)Ti_(1-x)Sn_y固溶度
3.
Elements with different solid solubility and mono-crystalline copper as well as polycrystalline austenitic stainless steel were used to discuss the long-range effects in metals and alloys implanted by ions with different solid solubility.
为研究金属及其合金基体中不同固溶度的注入离子引发的长程效应,采用固溶度相差较大的元素以及单晶和多晶为分析材料,用透射电子显微镜弱束成像技术研究了被注入材料的横截面样品。
5) solubility
[英][,sɔlju'biliti] [美][,sɑljə'bɪlətɪ]
固溶度
1.
Intracrytalline element solubility and mechanical property of a new super-high strength and toughness Al alloy cast under low frequency electromagnetic field;
低频电磁铸造超高强高韧铝合金元素晶内固溶度和力学性能研究
2.
Based on crystal lattice constant and solubility of tin oxide in ITO target were calculated by Vegard principle.
对400,500,600,700,800,900,1000℃温度下煅烧制得的氧化铟锡(ITO)粉体进行X射线衍射分析,利用Vegard定律分析得到的衍射数据计算出靶材的晶格常数和氧化锡在ITO靶材中的固溶度,得出ITO靶材中氧化锡的固溶度大小主要与温度有关,氧化锡相在靶材中的固溶度随着温度的升高而增大的结论。
3.
The solubility of the ceramic pigment was measured with an X-ray diffraction method by analyzing the crystal constant accurately.
用X射线衍射分析的方法,通过精确测定点阵参数,对陶瓷颜料固溶体的固溶度进行了测定,并取得了满意的效果。
6) solid solubility limit
固溶限度
1.
With the increase of the amount of Nb~ 5+ , the grains continued shrinking, but the effect didn’t continue any longer when the amount exceeded the solid solubility limit of Nb~ 5+ .
结果表明:各试样都形成了与BBT相同的单一相结构,说明适量氧化铋过量和B位Nb5+掺杂并未改变BBT陶瓷的晶体结构;随着Nb5+掺杂量的增加,晶粒尺寸持续降低,但是超过Nb5+的固溶限度后,细化效果不再明显增加;压电常数和相对介电常数随掺杂量增加先增后减,其峰值也出现在Nb5+的固溶限度处。
补充资料：固溶度
solidsolubility：溶质固溶于溶剂内所形成的饱和固溶体内溶质的浓度。在合金系相图内，不同温度下的固溶度，通称为固溶限。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条