1) microwave loss
微波损耗
1.
The experimentresults show that the microwave loss of BMT ceramic mainly depends on its B-site ion ordering pa-rameters, bulk density and homogenous microstructure.
实验结果表明，ＢＭＴ陶瓷的微波损耗主要与其密度、有序度和微观结构的均一度有关。
2.
The results show that the microwave loss of a CPW on LRS is too high to be used, but it can be greatly reduced by adding a thick interlayer of silicon oxide between the CPW transmission lines and the LRS.
结果表明,低阻硅衬底导致过高的微波损耗从而不能使用,通过加氧化硅介质层,微波损耗可以大大减少,但是需要较厚的氧化硅厚度。
2) wavelength minim-loss
波长微损耗
1.
Based on coupling theory,the relations between the attenuation and the changing parameters were analyzed and the wavelength minim-loss was discussed.
基于耦合波理论,分析了衰减量与改变参量之间的关系,讨论了波长微损耗特性。
3) microwave loss mechanism
微波损耗机理
1.
The fundamental research on fabricating microwave absorbing materials are systematically sum- marized in terms of physics and materials science,and the microwave loss mechanisms of traditional microwave ab- sorbing materials and a new microwave absorbing nano-material are discussed.
从物理学和材料学的观点,较为系统地总结了制备吸波材料的基础研究,并探讨了传统吸波材料及新型纳米吸波材料的微波损耗机理。
4) microwave dielectric loss
微波介电损耗
6) low loss InP based microwave waveguide
低损耗InP基微波波导
补充资料：介质损耗角正切试验(见电容率与损耗因数试验)
介质损耗角正切试验(见电容率与损耗因数试验)
dielectric loss tangent test
)!eZh.sunhooJ一002匕engq一e sh一yon介质损耗角正切试验(dieleetri。1055 tangenttest)见电容率与损耗因数试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条