1) capacitor ceramic
电容器瓷料
1.
The working condition is very harsh for ceramic capacitors used in vehicles as their maximum operating temperature is as high as 150℃,this article describes X8R capacitor ceramics which can meet such high requirements.
文内介绍满足这类用途的X8R电容器瓷料。
3) SrTiO3 systems mid-high voltage capacitor ceramics
SrTiO3基中高压电容器瓷料
4) heat-stable monolith ceramic capaci-tor material
热稳定独石电容器瓷料
5) high voltage ceramic capacitor materials
高压陶瓷电容器材料
1.
Prepared were the BaTiO3-based high voltage ceramic capacitor materials doped with SrTiO3,CaTiO3 and Bi2O3·3TiO2.
采用BaTiO3基料,加入SrTiO3、CaCO3、Bi2O3·3TiO2等添加剂制备无铅高压陶瓷电容器材料,研究了添加剂对材料性能的影响,得到了介电常数可调、综合性能较佳的材料。
6) ceramic capacitor
陶瓷电容器
1.
Densification process of Ni electrodes in ceramic capacitors;
陶瓷电容器镍电极的致密化过程
2.
Design of a novel capacitor: multifiber ceramic capacitor;
新型多纤维陶瓷电容器的设计
3.
An experimental investigation was undertaken to study the glass composition and content effects on the adhesion,square resistance and weldability of Ni electrodes in ceramic capacitors.
研究了玻璃粘结剂组成和含量对陶瓷电容器镍电极附着力、方阻和可焊性的影响,并使用SEM和EDS分析了其中的影响机制。
补充资料：电力电容器灌封料
分子式：
CAS号：
性质：树脂(A)为聚醚填充料等，固化剂(B)为改性异氰酸酯等。由聚醚与辅助材料经脱水精制后再加填充料和催化剂进行反应，然后经研磨混合、过滤而成。树脂为白色或黄色黏液。密度1.35～1.40g/cm3。黏度(25℃)7000mPa·s左右。固化剂为黑色或黄色黏液。密度1.10～1.15g/cm3，黏度(25℃)5500mPa·s左右。用于电容器元件特别适用于电力电容器的表面密封和固定。
CAS号：
性质：树脂(A)为聚醚填充料等，固化剂(B)为改性异氰酸酯等。由聚醚与辅助材料经脱水精制后再加填充料和催化剂进行反应，然后经研磨混合、过滤而成。树脂为白色或黄色黏液。密度1.35～1.40g/cm3。黏度(25℃)7000mPa·s左右。固化剂为黑色或黄色黏液。密度1.10～1.15g/cm3，黏度(25℃)5500mPa·s左右。用于电容器元件特别适用于电力电容器的表面密封和固定。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条