1) formulas for contact action
接触压力计算公式
3) non-contact tonometer
非接触式眼压计
1.
The comparison of intraocular pressure measurement between non-contact tonometer and Goldmann applanation tonometer;
非接触式眼压计与Goldm ann压平眼压计测量眼压的比较
2.
Objective To compare the intraocular pressure reading of dynamic contour tonometer(DCT)with those of Goldmann applanation tonometer(GAT)and non-contact tonometer(NCT)before and after LASIK,and compare the difference among their mea- surements.
目的比较动态轮廓眼压计(DCT)、Goldmann压平式眼压计(GAT)及非接触式眼压计(NCT)测量接受准分子激光原位角膜磨镶术(LASIK)患者眼压值的差异。
4) contact manometer
接触式压力表
5) contact pressure
接触压力
1.
Calculation of contact pressure on TM and VAMACE premium connection casing couplings;
TM和VAMACE特殊螺纹套管接箍接触压力计算
2.
The effect of articular step-off and neniscectomy on joint alignment and contact pressures for fractures of the lateral tibial plateau;
胫骨外侧髁骨折塌陷对关节轴线及接触压力的影响
3.
Single chip microcomputer-based inspection of catenaries-pantograph contact pressure;
基于单片机的弓网接触压力检测
6) contacting pressure
接触压力
1.
Research on contacting pressure in ball-spinning;
滚珠旋压工艺中成形区接触压力的分析计算
2.
A pin-on-disk test rig was used to investigate the influence of sliding speed and contacting pressure on the friction and wear behavior of 45CrNi pair under dry sliding condition.
利用销盘摩擦磨损试验机,考察了干滑动摩擦条件下滑动速度、接触压力对45CrNi摩擦副摩擦磨损性能的影响。
3.
The progressive cavity pump(PCP) distortions,forces and contacting instance of different pressure with the finite element analysis method are analyzed,the PCP two-dimension finite element model is constituted,the stress distributing correspond to the PCP stator rubber and the contacting pressure of the stator and rotor are obtained in this paper.
用有限元方法对螺杆泵在不同压力作用下的变形、受力及接触情况进行了分析研究,建立了螺杆泵的二维有限元模型,得出了在相应情况下螺杆泵定子橡胶的应力分布和螺杆泵定子与转子的接触压力。
补充资料：杀菌锅主要工艺计算——杀菌时的压力计算
         | |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条