2) rubber sheath
橡胶护套
1.
A high strength and tear rubber sheath being satisfactory to GB 12792-91 reguirement has been developed by adopting CR-G/CR-W blend with selected curing system and filling system.
采用Ｇ型、Ｗ型氯丁橡胶并用，并合理选用硫化体系、填充体系，研制出了满足ＧＢ１２９７２－９１要求的矿用电缆用高强度、高抗撕性能的橡胶护套。
3) rubber bush
橡胶衬套
1.
The importance and adoption principles of the rubber bush;
橡胶衬套在空气悬架中的重要作用和采用原则
2.
Direction compression technology of rubber bushes and their products design were introducted in this paper.
介绍了橡胶衬套的缩径工艺方法和缩径类衬套产品的设计。
4) rubber coat boot
橡胶套靴
1.
Using Jilin Chemical Industry Corporation EPDM as main material ,basic formulation and basic process of railway rubber coat boot and pad meeting the TKTJ 9904-1 standard of railway department are developed.
以吉化三元乙丙橡胶 (EPDM )为主要原料 ,开发出符合铁道部规定的TKTJ990 4- 1标准的铁路橡胶套靴及轨枕垫板基本配方和基本工艺 ,并已在河北某橡胶厂实现工业化生产。
5) rubber grip
橡胶把套
1.
A study was carried out on the vibration of rubber grips on gaslined chain saws.
本文对油锯橡胶把套的振动特性进行了实验研究。
6) rubber bushing
橡胶衬套
1.
Engineering algorithm on bending stiffness of elastic rubber bushing of car suspension;
轿车悬架弹性橡胶衬套弯曲刚度的工程算法
2.
High Accuracy Model Establishing and Applying of Axial Symmetry Rubber Bushing;
轴对称橡胶衬套高精度模型的建立及应用
3.
An approach to overcome steering linkage s vibration at high speed has been found through sensitive analysis of these rubber bushing of fore suspension and steering system and orthogonal DOE(Design of Experiment) optimization.
应用 ADAMS软件建立整车多体动力学模型 ,通过仿真分析和道路试验 ,研究转向机构高速振动的原因 ;对悬架和转向系各处橡胶衬套进行灵敏度分析和正交试验优化 ,探索抑制转向机构高速振动的途
补充资料：预应力水泥管橡胶套
分子式：
分子量：
CAS号：
性质：制造预应力水泥管时使用的橡胶模套，可以使制成的预应力水泥管具有强力高、壁薄、直径大、无需涂料、使用寿命长等优点。可以节约大量钢材。
分子量：
CAS号：
性质：制造预应力水泥管时使用的橡胶模套，可以使制成的预应力水泥管具有强力高、壁薄、直径大、无需涂料、使用寿命长等优点。可以节约大量钢材。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条