说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 冲刷速度
1)  Flush Speed
冲刷速度
2)  erode velocity
冲刷流速
3)  scour depth
冲刷深度
1.
The examinational study on the local scour depth of roadbed along river;
沿河路基局部冲刷深度的试验与分析
2.
Research on local scour depth calculation of roadbed along river;
沿河路基局部冲刷深度计算研究
3.
Investigation on characteristics and scour depth of flow in river bend;
河流弯道水流特点与冲刷深度探讨
4)  Flush Angle
冲刷角度
5)  scouring depth
冲刷深度
1.
Estimation method of scouring depth of lower reach of hydro-junction;
枢纽下游河床冲刷深度估算方法
2.
Discussion the scouring depth recommended by "Levee Engineering Design Standard";
对《堤防工程设计规范》推荐冲刷深度公式的探析
3.
Based on this research,the model nearby superposed flow spur and the velocity distribution of spur head flow were built,At last,a theoretical formula of scouring depth around pile permeable spur dike was derived from the models.
针对其区域水流特性及局部冲刷,通过理论分析,并结合试验验证,分析了其局部水头损失机理,得出了正挑桩式丁坝壅水高度的计算公式,建立了坝头水流的叠加模式和坝轴断面的流速分布式,导出了其局部最大冲刷深度的理论计算公式。
6)  depth of scour
冲刷深度
1.
Taking Bayin River Crossing as an example,which is only a sechis of Hydraulic Protection Project for Sebei-Xining-Lanzhou Gas Transportation Pipeline,we have calculated the depth of scour in this section by using the scouring empirical formulae that have been widely used in the pipeline engineering.
以"涩宁兰输气管道巴音河穿越段水工保护工程"为实例,采用管道河流穿越工程中广泛应用的冲刷经验公式,对该穿越段的冲刷深度进行计算,通过对比分析各计算结果的合理性与可靠性,提出了符合实际情况的水工保护工程基础埋置深度,为油气输送管道穿越段水工保护工程设计与工程基础埋深的确定提供了技术参考和较可靠的科学依据。
补充资料:冲刷
水流冲击引起河、渠及海岸、库岸等土石流失或剥蚀的现象。被冲刷的泥沙随水流运动,可能在其他地点淤积。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条