1) ferrites nitrocaburizing
铁素体氮碳共渗
2) salt bath ferritic nitrocarburizing
盐浴铁素体氮碳共渗
3) both nitrocarburizing
液体氮碳共渗
4) gas nitrocarburizing
气体氮碳共渗
1.
The microstructure morphology of 38CrMoAl steel axial plunger after gas nitrocarburizing and liquid sulpho-nitrocarburizing were analyzed and observed by optical microscope and SEM,and the chemical composition of the penetrated layer were measured qualitatively by energy spectrum analysis.
用金相显微镜和扫描电镜观察和分析了38CrMoAl钢轴向柱塞经气体氮碳共渗和液体碳氮硫共渗后的组织形貌,并且用能谱分析的方法定性地测定了渗层的化学成分。
2.
The effects of different ammonia flow on roughness and morphology of cool-rolled sheet steel after gas nitrocarburizing was studied by surface roughness measuring instrument and scanning electronic microscope (SEM).
研究了抛光冷轧钢板气体氮碳共渗时氨流量对共渗层表面粗糙度和形貌的影响。
3.
At the same time deals with the NH 3+CO 2+N 2 gas nitrocarburizing process,microstructure and property of nitrocarburized layer.
介绍了全密封箱式氮碳共渗生产线的结构、性能、工艺流程、NH3+CO2 +N2 气体氮碳共渗工艺、共渗层的显微组织和性能 ,以及在BJ4 93Q型柴油机曲轴生产上的应用。
5) liquid sulpho-nitrocarburizing
液体碳氮硫共渗
1.
The microstructure morphology of 38CrMoAl steel axial plunger after gas nitrocarburizing and liquid sulpho-nitrocarburizing were analyzed and observed by optical microscope and SEM,and the chemical composition of the penetrated layer were measured qualitatively by energy spectrum analysis.
用金相显微镜和扫描电镜观察和分析了38CrMoAl钢轴向柱塞经气体氮碳共渗和液体碳氮硫共渗后的组织形貌,并且用能谱分析的方法定性地测定了渗层的化学成分。
6) liquid carbonitriding
液体碳氮共渗
1.
A new agent produced from nontoxic material for liquid carbonitriding has been made in our works.
将市售普通无毒原料处理后,与木炭粉等配制的渗剂用于液体碳氮共渗,其处理效果极佳。
补充资料：共析铁素体
eutectoidferrite：共析成分的奥氏体发生共析相变（共析相变）所形成的共析体（本意的珠光体）内的铁素体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条