1) minimum superheat
最小过热度
1.
Numerical calculations of minimum superheat, (which is neededto avoid delivery tube blockade due to metal premature solidification), are conducted fordifferent liquid metals (Fe, Zn, Al ), and process parameters.
应用有限差分对喷射成形导流管中的液态金属的流场进行模拟，计算液态金属Fe，Al，Zn在不同过程参数条件下所需的最小过热度△T，得出了最小过热度和材料热物理性质及过程参数之间的半定量关系。
2) Minimum subcooled temperature
最小过冷度
3) highest superheating temperature
最高过热温度
1.
Following this weakly first order phase transition, the temperature dependence of enthalpy near the transition indicates that the lowest supercooling temperature of the isotropic phase T~*, the N-I phase transition temperature T _C and the highest superheating temperature of the nematic phase T~(**) are very close to each other.
在这种弱一级相变附近焓随温度的变化表明 :各向同性相最低过冷温度T 、N I相变温度TC 和向列相最高过热温度T 彼此十分接近。
4) maximum overtemperature
最大过热温度
5) minimum heat flux (MHF)
最小热流密度
1.
A theoretical analysis was carried out for predicting the minimum heat flux (MHF) point of the boiling curves for the water jet impingement boiling on the horizontal high temperature plate at the jet stagnation zone having the same size as the nozzle.
运用两相流边界层理论 ,对高温平板上过冷水自由喷流沸腾传热曲线最小热流密度点所对应的稳定蒸汽层内蒸汽极限流动条件进行了理论假定 ,得到了计算最小热流密度点热流密度和壁面过热度的半理论式 。
补充资料：最小辐亮度与最小辐照度(见核爆炸火球)
最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance
zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条