1) palladium dispersion
钯分散态
2) dispersion of palladium
钯的分散状态
3) Dispersed Pd nanoparticles
分散态钯纳米粒子
4) palladium diffuser
钯扩散器
5) Dispersion morphology
分散形态
1.
The effects of solution concentration,the voltage and the distance between two electrodes on dispersion morphology and diameter of the fibers were observed by using Field Emission Scanning Electron Microscope(FESEM),and the effects of solution concentration and the voltage on crystallization behavior of fibers were also characterized with XRD.
运用场发射扫描电镜(EFSEM)观察了纺丝液的浓度、电压、固化距离等参数对尼龙66电纺纤维膜的纤维分散形态和直径大小的影响,运用XRD分析了纺丝液浓度和电压对电纺纤维结晶度的影响。
2.
The dispersion morphology of nanocomposites was characterized by FESEM.
采用FESEM对复合材料中纳米粒子的分散形态进行表征,结果表明,当纳米Al2O3粒子含量为3%时,绝大多数的纳米粒子以<100nm的尺寸均匀分散在基体中;采用FTIR对纳米复合材料的结构进行表征,结果表明,纳米Al2O3与LLDPE之间形成了化学键合结构;力学分析表明,纳米复合材料的拉伸强度及断裂伸长率均有所增加;采用SEM观察拉伸断裂面的形貌,结果表明,适量的纳米Al2O3粒子可以增强、增韧聚合物基体,而基体和纳米粒子的相容性差时,会逐渐引入缺陷。
6) dispersion state
分散状态
1.
Effect of cure methods on clay dispersion state in rubber/clay nanocomposites;
硫化方法对橡胶/黏土纳米复合材料黏土片层分散状态的影响
2.
The dispersion state of nickel ions on γ-Al2O3 and the catalytic hydrogenation activity of supported Ni/γ-Al2O3 catalysts have been studied by means of X-ray diffraction (XRD), UV-Vis diffuse reflectance spectroscopy (DRS), H2 temperature-programmed reduction (TPR), CO chemisorption and microreactor tests.
用X-射线衍射(XRD)、紫外-可见漫散射光谱(UV-VisDRS)、程序升温还原(TPR)、CO化学吸附和微反测试等方法研究了Ni2+在γ-Al2O3上的分散状态和负载型Ni/γ-Al2O3催化剂的α-蒎烯加氢催化活性。
3.
Such techniques as LRS and TPR were used to study the surface dispersion state of WO_3 on the surface of TiO_2-SiO_2 complex support.
应用LRS和TPR技术研究WO3在复合载体TIO2-S iO2表面的分散状态,发现TiO2在S iO2表面的分散可增强WO3与载体之间的相互作用,提高WO3在载体表面的分散阈值。
补充资料：单线态-单线态能量转移
分子式：
CAS号：
性质：处于电子激发单线态的能量给体，通过激发能的转移使能量受体处于激发单线态的过程。
CAS号：
性质：处于电子激发单线态的能量给体，通过激发能的转移使能量受体处于激发单线态的过程。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条