1) ideal critical diameter
理想临界直径
2) Critical diameter
临界直径
1.
The ratio of the critical diameter of the particles captured by filter cylinder at different direction of fluid passing, according to the capturing condition of the frictional force between the particle and the narrow passages surface more than the particless drag force, was calculated.
本文利用Ｓｔｏｋｅｓ定律关联了滤芯层中微粒的曳力与位置的关系，按颗粒与孔道壁面摩擦阻力大于曳力的去除条件，计算了两种不同流向时滤芯截除微粒临界直径之比。
2.
And the interrelationship of critical diameters of ANFO and AL-ANFO Explosives to charging density and confined materials has been gotten.
对影响两种粒状炸药(ANFO,AL-ANFO)爆轰性能的主要因素(装药密度、装药直径、约束条件等)进行了实验研究,获得了粒状炸药临界直径与装药密度、约束条件等的相互关系。
3.
This paper studies on the critical diameter of emulsion matrix.
本文在对乳化基质和乳化炸药临界直径分析和探讨的基础上,通过专门设计的压药装置进行密实装药,测定了乳化基质和乳化炸药不同套管的临界药层厚度,并讨论了拐角效应和弯管效应的熄爆现象,对拐角管装药和螺旋弯管装药进行了爆速测量,定量分析了其熄爆机理。
3) diameter critical graphs
直径临界图
4) ideal diameter
理想直径
5) critical hardenable diameter
临界淬透直径
1.
The results show that the C-curve of the micro boron alloged P20 is somewhat shifted to the right and formation of proeutectoid ferrite is restrained,the critical hardenable diameter(for oil quenching) is increased from 380 mm to 500 mm.
研究了硼对塑料模具钢P20的淬透性能的影响,结果表明:微量硼使P20钢的铁素体形成区域C形鼻尖发生右移,加硼后先共析铁素体的形成得到明显抑制;在油淬的条件下,P20钢的临界淬透直径由380 mm增加到近500 mm。
6) critical adiabatic diameter
临界绝热直径
补充资料：临界理想
临界理想
critical ideal
临界理想汇苗柱因ide川;冲.Tep.泛助ea月」I补注)同分歧素理想(ramified prime ideal).
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条