1) interlayer purity
层间纯度
2) High-pure m-phenyldiamine
高纯度间苯二胺
3) interpass temperature
层间温度
1.
Preheat and interpass temperature were determined,the welding material was choosen,the relevant process parameters,the welding procedure and the heat-treatment procedure were worked-out.
研究了T91与10CrMo910钢的异质焊接工艺,确定出预热和层间温度,选择了焊接材料,制订出相应的工艺参数和焊接、热处理工艺。
2.
The influence of welding heat input and interpass temperature on the impact value of the welded joint -30℃temperature are analyzed.
分别就焊接线能量、层间温度变化对焊接接头的-30℃冲击韧性的影响进行了试验,并用光学显微镜和电子显微镜观察了接头组织。
3.
In this paper,it adopts process actions,such as preheating,controlling heat input and interpass temperature,post-heat and slow cooling and it makes use of relative detecting method to impect the guality in low temperature welding.
通过采取焊前预热、控制焊接线能量和层间温度、焊后保温缓冷等工艺措施,并采用相应的检测方法,保证了胺液吸收塔的低温焊接质量。
4) interlayer temperature
层间温度
1.
According to the test,the welding interlayer temperature of X60 pipeline in the normal and low temperature is analyzed in order to study the influence of its variable range on welding quality.
针对涩北至格尔木天然气管道复线建设中采用的X60管线钢,根据试验,分析了常温与低温焊接时层间温度变化对管口焊接质量的影响,并指出了防止涩格天然气管道焊接产生冷裂纹的工艺措施。
5) interlaminar strength
层间强度
1.
Methods of improving the interlaminar strength of fabric-reinforced laminates;
织物增强复合材料层合板层间强度的改善方法
6) story stiffness
层间刚度
1.
Sensitivity analysis of frequency and mode to the story stiffness of a shear structure;
频率与振型对剪切型结构层间刚度的灵敏度分析
2.
On the basis of the dynamic behaviour of the layered soil foundation frame complex system,the story stiffness and damping is decomposed from the total system and the asymptotic identification equation of story stiffness and damping is deduced by means of the least square method.
对于层状地基 -基础 -框架这一复合系统 ,将层间刚度和阻尼从总体系统中分离出来 ,依据最小二乘识别法则 ,导出了层间刚度和阻尼参数识别的递推方程 ,以此为基础建立了该复合系统的时域参数识别方法。
3.
On the basis of the motion characteristic of shear building,the story stiffnesses and dampings are decomposed from the total system and the asymptotical identification equation of story stiffness and damping is deduced by means of the least-square method.
根据集中剪切型系数的运动特征 ,将层间刚度和阻尼从总体系统中分离出来 ,依据最小二乘识别法则 ,导出了层间刚度和阻尼这些层间参数识别的递推方程 ,以此为基础建立了地基—基础—框架相互作用系统的参数识别方法。
补充资料：层间剥离
分子式：
CAS号：
性质：层压材料在受到外部不均匀应力的作用下，在层与层之间发生的剥离破坏称为层间剥离。
CAS号：
性质：层压材料在受到外部不均匀应力的作用下，在层与层之间发生的剥离破坏称为层间剥离。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条