1) CMS
分子筛炭织物
1.
PREPARING THE PRECURSOR OF CMS BY H_2O ACTIVATION METHOD;
水蒸气活化法制备分子筛炭织物的前驱体
2) carbon molecular sieve
炭分子筛
1.
A Dynamic Gas-Water Imbibition Technique for Evaluation of the Air Separation Ability of Carbon Molecular Sieves;
吸水驱气法评价炭分子筛空分性能
2.
Carbon molecular sieve (CMS) with a specific surface area over 3 000 m2/g is obtained from Daqing petroleum coke by KOH activation.
以大庆石油焦为原料,采用物理化学联合活化法制备炭分子筛,考察了碱炭比、活化温度、活化时间对炭分子筛吸附性能的影响,确定了最佳工艺条件并制得比表面积近3 000 m2／g的炭分子筛。
3.
A carbon molecular sieve with a mesopore ratio>85% and S_(BET)>1?500?m~2/g was then obtained from the UAC through heat-treatmen.
通过热处理得到孔径均一(中孔率>85%),比表面积大于1500m2 g的炭分子筛;再用表面氧化方法,得到表面酸度适宜(150℃～240℃之间为弱酸,240℃～340℃为中强酸,340℃～450℃为强酸分布)的催化剂载体。
3) CMS
炭分子筛
1.
The Influence of Carbonization Condition and Iron SeriesAdditives on Carbon Molecular Sieve(CMS) Performance;
炭化条件和铁系添加剂对炭分子筛性能的影响
2.
INFLUENCE OF CARBONIZATION CONDITIONS AND Fe ADDITIVE ON CMS(Carbon Molecular Sieve) PROPERTIES;
炭化条件和铁系添加剂对炭分子筛性能影响的研究
3.
The thesis investigates the feasibility on the CMS manufacturing by hydrothermal upgrading of lignite and the influence on CMS capability of air separation by altering the technics condition of hydrothermal upgrading of lignite.
研究了褐煤原料经热处理改质后制备炭分子筛的可能性,并考察了热解改质的工艺条件对产品空分性能的影响。
4) carbon molecular sieves
炭分子筛
1.
Preparation and Application of Carbon Molecular Sieves;
炭分子筛的制备及其应用
2.
In order to obtain the precursor of the carbon molecular sieves (CMS) with developed microprosity,the one step carbide of the walnet shell was firstly preoxidised with H 2O 2 of different concentration,followed by moldeling and post carbonizaton.
为获得具有发达孔结构的炭分子筛前驱体 ,在室温下使用不同浓度 H2 O2 溶液对核桃壳的一次炭化物进行预氧化处理 ,并做进一步的成型和二次炭化 。
5) carbon molecular sieve membrane
炭分子筛膜
1.
Preparation of tubular carbon molecular sieve membranes for gas separation;
气体分离用管状炭分子筛膜
2.
Preparation and modification of carbon molecular sieve membranes
炭分子筛膜的制备与改性
3.
Carbon molecular sieve membrane (CMSM) is a new material in gas separation with high efficiency and low energy consumption, and has drawn much attention in the past several decades because of its high gas selectivity, high thermal and chemical stability.
炭分子筛膜是一种用于气体分离的高效、节能的新型材料 ,具有好的气体分离选择性 ,高的热和化学稳定性 ,近年来得到国内外广泛的重视和发展。
6) carbon molecular sieve membrane
分子筛炭膜
1.
Surface coating is one of effective methods for preparing carbon molecular sieve membrane (CMSM ).
表面涂层法是制备分子筛炭膜的有效方法、以酚醛树脂的乙醇溶液作为涂层液对炭膜基板进行处理，制得适合H2/CO2分离的分子筛炭膜。
2.
A certain concentration of PF solution served as carbon material was used to manufacture carbon molecular sieve membrane.
以一定浓度的酚醛树脂溶液对炭膜基板进行碳沉积处理，考察碳沉积条件对所制备的分子筛炭膜气体分离性能的影响。
补充资料：10X分子筛
分子式：0.70CaO·0.30Na2O·Al2O3·(2～3)SiO2·6.0H2O
CAS号：
性质：白色粉末。具有高的吸附性和抗毒性。由水玻璃、偏铝酸钠、氢氧化钠按一定摩尔比混合后，发生反应，经结晶，过滤，洗涤，加入氯化钙进行离子交换(交换率70％)再过滤，再洗涤，烘干，加入粘接剂捏合，成型，灼烧活化制得。用于气体、液体的干燥，气体中硫化物、二氧化碳的脱除，芳烃的分离，以及用作催化剂及载体。
CAS号：
性质：白色粉末。具有高的吸附性和抗毒性。由水玻璃、偏铝酸钠、氢氧化钠按一定摩尔比混合后，发生反应，经结晶，过滤，洗涤，加入氯化钙进行离子交换(交换率70％)再过滤，再洗涤，烘干，加入粘接剂捏合，成型，灼烧活化制得。用于气体、液体的干燥，气体中硫化物、二氧化碳的脱除，芳烃的分离，以及用作催化剂及载体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条