1) rolling die
辊式模
1.
This paper recommends some techniques, such as back tension drawing, rolling die drawing, force-feed lubrication drawing,drawing without acid and superplastic drawing,which are being studied or applied at home and abroad,and have high theoretical and practicable values in reducing the cost of energy sources in drawing.
本文介绍了反张力拉拔、辊式模拉拔、强制润滑拉拔、无酸拉拔、超塑性拉拔等新技术，这些是国内外正在研究或已实际应用的新工艺，对解决拉拔工艺的高能耗问题有较高的理论与实用价值。
2) two-joint roller dies
二连式辊模
3) driven roller die
被动式辊拉模
1.
Based on the drawing characteristics,the driven roller die is modified to drive roller die for drawing special-shaped wire of low plastic deformation metal.
结合轧制的特点,将被动式辊拉模变成主动式用于拉拔低塑性金属异型材。
4) drive roller die
主动式辊拉模
5) Turks head
组合式辊压模
6) roller die push bench
辊式模顶管机
补充资料：辊辊
1.犹混混。形容苟且混世。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条