1) Electric Spark
电火化
2) coating tester
胶布（静电火化）测定器
3) EDM
电火花
1.
Power Supply for Ultrasonic Motor Applicable to EDM;
适合于电火花加工的超声马达驱动电源的研制
2.
Gas Flow Field Simulation During Ultrasonic Vibration Assisted Gas Medium EDM Based on Fluent Software;
基于Fluent的超声振动-气体介质电火花加工气体流场模拟
3.
Machining Curve Surface Cavities of Mould by Trepanning Technology of EDM;
模具型腔三维曲面的电火花套型加工
4) Electrical Discharge
电火花
1.
Numerical simulation of temperature field for electrical discharge strengthened coating;
电火花表面强化层温度场的数值模拟
2.
A new EDM technology-ultrasonic vibration assisted electrical discharge machining in gas was proposed and corresponding experimental equipment was designed.
简述了超声振动辅助气体介质电火花加工原理,并设计开发了相应的实验机床。
3.
The surfaces of U70MnSi and 40Cr were strengthened by a self-made electrical discharge surface strengthening equipment using hard alloy YG-8 and FW-1101 as electric pole.
采用硬质合金YG-8和堆焊焊条FW-1101作电极,在电火花表面强化器上分别处理了U70MnSi钢和40Cr钢的表面。
5) electrospark
电火花
1.
lnterfacial behavior of filled joints by electrospark overlaying;
填充型电火花精密堆焊接头的界面结合行为
2.
Microstructure and properties of electrospark surface strengthening layers;
电火花表面强化层组织结构和性能的研究
3.
Electrospark surface strengthening technique and machine;
电火花表面强化工艺及设备
6) electric spark
电火花
1.
Analysis and verification of the machining mechanism of air mixed electric spark;
混气电火花加工机理的分析及验证
2.
Evaluation of Uncertainty in Determination of Carbon in Low Alloy Steel by Electric Spark-Direct Reading Spectrometry;
电火花直读光谱法测定低合金钢中碳的测量不确定度评定
3.
Determination of Iron,Silicon,Copper,Manganese,Magnesium, Titanium and Zinc in Pure Aluminum Sheets by Electric Spark Direct Reading Spectrometry;
电火花-直读光谱法测定纯铝薄板中的Fe、Si、Cu、Mn、Mg、Ti、Zn
参考词条
补充资料：火化少阳
火化少阳
火化少阳 运气术语。三阴三阳分司六气，其中少阳属相火之气。《素问·至真要大论》：“少阳司天，其化以火。”
说明：补充资料仅用于学习参考，请勿用于其它任何用途。