说明：双击或选中下面任意单词，将显示该词的音标、读音、翻译等；选中中文或多个词，将显示翻译。
您的位置：首页 -> 词典 -> 矫直变形理论
1)  straightening deformation theory
矫直变形理论
1.
A new discussion about straightening deformation theory on roller straightener;
辊式矫直机的矫直变形理论新探
2.
In this article, several straightening schemes are calculated with straightening deformation theory.
应用矫直变形理论对辊式矫直机的矫直方案进行了计算分析、比较和优选 ,并对最优方案下各矫直辊的压下量进行了计算 ,用于指导生产实践 ,取得了良好的效
2)  Deformation of straightening
矫直变形
例句>>
3)  straightening theory
矫直理论
例句>>
4)  creep straightening
蠕变矫直
5)  straightening strain
矫直应变
1.
The article introduces the basic principle to realize the quality improvement of continuous cast slab using multipoint straightening technique and the reasonable control of strain distribution and rate;also offers the number of straightening points,radius of curvature Ri,straightening strainεi and calculation method of strain rate.
介绍矫直点数N、曲率半径Ri、矫直应变εi和应变速率计算方法。
6)  deformation theory
形变理论
1.
HT5SS]The method of fast finite element analysis of sheet metal forming based on deformation theory was explored, and the computer program was implemented.
研究了基于形变理论的金属板料成形快速有限元分析的方法——反向方法 ,并实现了计算程序。
2.
The theory and method of finite element analysis of sheet metal forming based on deformation theory was explored, and the computer program was implemented.
研究了基于形变理论的金属板料成形有限元分析的理论和方法，并实现了计算程序。
3.
The residual stress around a coldworked hole is computed with elasto-plastic finite element methods of both flow theory and deformation theory.
本文为了检验形变理论在计算钉孔挤压残余应力场的可用性,对同一模型分别釆用全量法和增量法进行有限元计算,计算结果表明:在小的挤压量下,即δ≤2％(挤压量δ定义为(D_棒-D_板)/D_板×100％),两种方法均可釆用,当挤压量较大,即δ>2％时,全量法的结果与边界条件吻合得不好,而增量法符合得很好。
更多例句>>
补充资料：鞍山钢铁(集团)公司大型厂热矫直机矫直型钢


鞍山钢铁(集团)公司大型厂热矫直机矫直型钢


鞍山钢铁(集团)公司大型厂热矫直机矫暴
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条