Effect of Organic Ammonium Salts on the Surface Activity and Solubility of Fluorocarbon Surfactant;

Causes analysis of high solubility of TAT skin test solution and the countermeasures

The solubility properties of RECl3-Ser-H2O system(RE=Nd,Gd,Yb) at 25℃ in the whole cocentration range have been systematically investigated by semimicro phase equilibrium method.

Determination of solubility of methane in mixture of atmospheric No.3 diesel oil-tetrahydrofuran under high pressure;

Solubility parameter method for supercritical fluids solubility calculations;

The effects of different drying process on solubility and structure of ALSPC;

Preparation of Jizhen Drop Pills and its Dissolution;

Preparation and Dissolution of Sulfamethoxazole Solid Dispersion;

Determination of the Dissolution of Amantadine hydrochloriole tablets;

Effect of solid solution temperatures on the mechanical properties and microstructure of sand-cast samples of ZL210A cast aluminum alloy;

Effects of solution temperature on precipitation of β-Mg_(17)Al_(12) phase and mechanical properties of AZ80 magnesium alloy;

Influence of solution temperature on microstructure and toughness of weld joint in 2205 duplex stainless steel

This article was about the determination of the same sample's absorbent on the condition of different solution temperature, different still time and different water bath temperature,From it we could prove that the result was relative to different experiment conditions.

It were found that the swelling degree of AC-CA membrane was higher than THF-CA membrane in ethanol,the separation effect of AC-CA membrane was better than THF-CA membrane,the tensile strength of membrane was consistent with the content of cellulose acetate,the acid base ra.

Effects of temperature and pH value on their swelling degree and swelling rate were discussed.

The optimum conditions for preparing the nanocomposites were determined according to the swelling degree change of samples in acetone.