1) shapede formation
形状变形量
2) shape variable
形状变量
1.
Based on the curve theory in differential geometry, we introduce for general control systems the concepts of shape variable, the controlled shape-trace curve and the shape congruence control.
针对一般控制系统,利用微分几何中的曲线理论提出了形状变量、被控形状轨迹曲线和形状合同控制等概念。
3) deformation shape
变形形状
4) Shape design variable
形状设计变量
6) deformation behavior
变形性状
1.
Influence factor analysis of deformation behaviors for reinforced backfills behind abutment;
桥台后加筋回填变形性状影响因素分析
2.
FEM Analysis on Deformation Behavior of Deep Excavation Considering Foundation Pile;
考虑工程桩的存在对深基坑变形性状影响的有限元分析
3.
0,analyzes the deformation behavior of single-pile composite foundation under the action of horizontal load, discusses the influences of the size of vertical load and thickness of cushion on horizontal displacement of pile top,and shows by researching results that big vertical load and thick cushion course can reduce the displacement of pile top,which is propitious for the safety of pile.
0对复合地基进行了有限元仿真分析,分析了单桩复合地基在水平荷载作用下的变形性状,主要讨论了竖向载荷大小和垫层厚度不同对桩顶水平位移的影响,研究结果表明:竖向载荷越大,垫层厚度相对较大,都会减小桩顶位移,有利于桩身安全。
补充资料：变形区形状系数
变形区形状系数
parameters of deformation zone
b ianxingqu xingzhuang xishu变形区形状系数(parameters of deformationzone)通常指反映变形区几何特征及这些特征在轧制过程中对应力状态影响程度的轧件和工具尺寸的。~一~一，二。，了二H十川，，，。小二，，~参数，主要有z仄、R仄(万一号二}，H/D或从/D。式中D、R、H、h、万、l分别指轧辊直径、轧辊半径、轧件轧前厚度、轧件轧后厚度、轧件平均厚度、变形区长度。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条