1) charging equipment
上料设备
2) charging
上料
1.
Reformation of automatic charging system for 120 t converter in Jinan Iron and Steel (Group) Corporation;
济钢120t转炉自动上料系统的改造
2.
A brief introduction was made on application of Fuji G11s series frequency converters in charging system of No.
简要介绍了富士G11S系列变频器在马钢第二炼铁厂4#高炉的上料卷扬系统中的应用,着重说明了对于重载起动与提升负载应采取的措施与注意事项。
3.
The investment and the operation expenses vary according to the charging modes for blast furnace.
高炉上料方式不同,投资和运行费用也不同,本文比较了750 m3和1500 m3级高炉料车上料与皮带上料的优缺点,提出在无总图布置优势条件下,宜采用料车上料方式,以节约投资,降低运行费用。
3) feeding
上料
1.
Application of PLC in automatic feeding, screening and conveying system;
自动上料、筛选及输送系统中的PLC控制
2.
Based on the original design of electromagnetic vibrating feeder,an electric vibrator feeding device was designed to solve the problem of less amount pieces brought by the original electromagnetic vibrating feeder.
分析了长尾夹装配的工艺流程,基于电磁振动原理,设计了用于长尾夹装配的电磁振动上料器,并对其自动定向整列机构做了详细的介绍。
4) charging pattern
上料模式
5) charging passage
上料通廊
1.
By calculating accurately the hoisting points load for each crane in the charging passage is determined and the passage assembling reaches the design requirement.
介绍了3200m3高炉主皮带通廊钢结构安装工程概况和特点,对上料通廊支架多机吊装时精确计算吊点,确定各个吊机的负荷,确保了通廊安装最终达到设计要求。
6) charging system
上料系统
1.
Application of programmable controller S5-115U to charging system of No1 blast furnace at Anyang Iron & Steel Co.;
可编程序控制器S5—115U在1号高炉上料系统的应用
2.
The basic situation of equipments of the feeding and charging system of BF and the operation are introduced.
介绍了高炉供、上料系统的设备基本情况和施工过程。
3.
The project general situation,main process flow and equipment configuration of the charging system for the stainless and carbon steel smelting project of Stainless Steel Branch are introduced.
介绍了不锈钢分公司不锈钢项目炼钢工程上料系统的工程概况、主要工艺流程和设备配置,重点就设计中采用的新工艺、新技术作了总结。
参考词条
补充资料：料料窕窕
1.形容人的身材过于瘦长。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。