1) permutation load current systl
负载换流供电系统
2) load commutated inverter
负载换流
1.
The Brushless DC Motor can operate on the load commutated inverter(LCI)drive system because of its utility.
研究了运用数字信号处理器(TMS320F240)实现负载换流的无刷直流电动机驱动系统。
3) onboard power system
车载供电系统
1.
This article presents the comprise,working concept and technical parameters of the main circuit and control circuit of the on-ground power system and onboard power system for test line of Shanghai low-speed maglev train.
对上海低速磁浮列车试验线的地面供电系统、车载供电系统的主电路和控制电路的结构组成、工作原理和技术数据进行了详细的分析和说明。
4) carrier supply system
载供系统
5) load current
负载电流
1.
Single-phase parallel hybrid active power filter adopting novel control approach of load current detection;
采用负载电流检测控制方式的单相并联混合型有源电力滤波器
2.
The principium of hot rolling bar shear controlled by T400,and the effect of speed set-point characteristic to load current are analyzed.
针对热轧棒材倍尺飞剪高速剪切时存在速度滞后并超调,影响产品质量,制约生产线运行速度的问题,对采用T400工艺板控制的热轧棒材倍尺飞剪,从原理上解析速度给定曲线对负载电流的影响,以参数化编程的方式实现控制方案优化。
3.
The analysis and Matlab simulation results show that the proposed controller greatly improves the dy- namic behavior of buck converter caused by fast variation of input voltage and/or load current,features clear physical meaning and easy design.
针对Buck变换器快速动态响应的要求,本文提出了一种具有快速动态响应速度的非线性控制方法——根据负载电流调节的电感电流滞环控制。
6) loading current
负载电流
1.
Based on the theoretical analysis of each factor inducing vibration of core and winding, the experiments validated that the fundamental frequency magnitudes of core and winding vibrations are linear to square of no-load voltage and loading current respectively.
在理论研究影响铁心及绕组振动各因素的基础上,实验验证了在空载状态下油箱表面测得的,铁心振动信号的基频幅值与施加电压的平方以及绕组振动信号的基频幅值与流过绕组的负载电流平方都呈较好的线性关系。
补充资料：城市供电系统 power supply system
由城市供电电源，输配电网和电能用户组成的总体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条