1) wireless test
![点击朗读](/dictall/images/read.gif)
无线测试
1.
The paper brings forward the design principle and a scheme of whole design of intelligence wireless test device based on the current requst of speediness and flexibility to aero-device test.
文中根据当前对航空武器装备检测快速性、灵活性的要求出发,提出了智能无线测试系统的总体设计方案,同时详细介绍了基于集成蓝牙技术的 nRF903芯片设计原理和硬件解决方案,给出了相应的实际电路。
2.
This paper introduces a general specifications about Bluetooth RF and its test methods and describes the solution of the Agilent Bluetooth wireless test in detail.
本文讨论蓝牙无线测试的基本指标及其测试方法,并着重介绍了安捷伦蓝牙无线测试解决方案。
2) wireless testing
![点击朗读](/dictall/images/read.gif)
无线测试
1.
The paper introduces a data transmission method for wireless testing of oilwell underpit parameters (pressure and temperature) and low power consuming control circuits of underpit emission devices.
介绍一种油井井下参数(压力、温度)无线测试的数据信息传输方法及井下发射装置低功耗控制电路。
3) wireless measurement system
![点击朗读](/dictall/images/read.gif)
无线测试系统
1.
Smart nickel powder-filled cement-based composites and its wireless measurement system are developed for health monitoring of concrete structures.
首先,给出了填充镍粉的水泥基材料的应力/应变传感单元的制备方法、测量原理和性能分析;其次,制作了应力/应变的无线测试系统;最后,完成了机敏镍粉水泥基材料的无线应力/应变测试系统的实验。
4) wireless network measurement
![点击朗读](/dictall/images/read.gif)
无线网络测试
5) Bluetooth wireless test set
![点击朗读](/dictall/images/read.gif)
蓝牙无线测试仪
6) radio telephone tester
![点击朗读](/dictall/images/read.gif)
无线电话测试器
补充资料:测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条