1) Membrane strength
膜强度
1.
Membrane strength decreased with the increase of demulsifier.
针对模拟采出液和三元复合驱矿场采出液，研究了破乳剂对复合体系界面张力和膜强度的影响。
2.
It was found that the membrane strength was affected significantly by the concentration of sodium alginate,membrane-forming time and molecular weight of poly-L-arginine.
结果表明,通过改变实验条件,可有效地控制微囊膜的膜强度,从而为进一步的药物控制释放实验打下一定的基础。
2) film strength
油膜强度
1.
Through the reasearch we found that when additives put into grease, their film strengths, infiltration degrees and dropping points are varied.
研究发现,加入不同的添加剂使润滑脂的油膜强度、锥入度和滴点产生不同的变化,并对其产生的原因作了机理分析。
2.
Film strength is an important parameter of roll oil．The relationship between filmstrength of lubricant and the concentration of different additives has been tested．The effectsof additive structure on film strength has been analyzed．The compound mechanism and theusing condition of additives in lubrication have been discussed.
实验测定了润滑油油膜强度与各种极性添加剂浓度的关系，分析了极性分子的极性基和非极性基结构对润滑油油膜强度的影响，指出了边界吸附膜的形成及强度对润滑剂油膜强度的决定作用，并讨论了添加剂的复合作用机理及其应用条件。
3) strength of water film
液膜强度
1.
This article puts forward a simple and effective studying method and studies the strength of water film influenced by chemicals in producing sewage by the ASP-flooded.
本文采用一种简便而有效的研究方法 ,研究了三元组分对液膜强度的影响。
4) filmstrength
浆膜强度
5) interfacial film strength
界面膜强度
1.
Water/crude oil interfacial tension,interfacial film strength and percentage of removed water from crude oil emulsions in the presence of demulsifiers was measured.
测定了在破乳剂作用下原油乳状液的油水界面张力、界面膜强度及破乳脱水率。
6) strength of lubricant film
润滑膜强度
1.
The influences of calcium stearate(CaSt_2) on the lubricating effects of paraffin wax,polyethylene wax(PE wax)and stearic acid(HSt) were discussed in detail and analyzed theoretically,and thus the concepts of "strength of lubricant film" and "rivet effect" were proposed.
详细地论述了硬脂酸钙(CaSt2)对石蜡、聚乙烯蜡(PE蜡)、硬脂酸(HSt)润滑作用的影响,并进行了理论分析,提出了“润滑膜强度”及“铆钉作用”概念。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条