1) oily cuttings
含油钻屑
1.
It is unavoidable to have large amount of oily cuttings generated from using oil base drilling fluid.
使用油基钻井液必然会产生大量含油钻屑。
2) oil cutting
含油岩屑
1.
The solid powder fluorescence of oil cuttings was studied and we drawn a conclusion that in the range of certain oil concentration, the fluorescence intensity of the solid powder is linear with oil concentration in the powder of cuttings, with a regression coefficient of 0.
通过对含油岩屑固体粉末荧光的研究, 指出了在固体粉末中含油浓度在一定范围内时,其粉末荧光强度与含油的浓度成线性关系,对二者关系进行线性拟合,其相关系数R=0。
2.
In this paper,a new method on direct assay of oil's fluorescence in oil cuttings was suggested according to the characteristic of oil cuttings.
针对含油岩屑的特点提出了一种直接对含油岩屑中油组分进行荧光测量的方法。
3) drilled solids to bentonite solids ratio
钻屑-般土比油矿
4) drilling sludge
钻屑
1.
The blasting effect was checking using sight instrument, electromagnetic emission (EME) technique and drilling sludge methods.
采用矿用钻孔窥视仪并配合电磁辐射法和钻屑法对爆破进行了效果检验。
2.
This paper discusses anew method of caculating critical rotational speed on the basis of studying the transportation rule of long screw drilling sludge and points out that critical rotational speed changesradially along the blade,and it is the function of feed speed.
作者在研究长螺旋钻进钻屑运移规律的基础上，建立了新的临界转速计算方法，指出临界转速沿叶片径向是变化的，并且是给进速度的函数。
5) drilling cutting
钻屑
1.
The solidification treatment of drilling cutting and waste drilling fluid is a major research subject on harmless treatment of waste from drilling at present.
钻屑和废钻井液的固化处理是现阶段钻井废物无害化处理的主要研究方向,研究利用固化剂对钻屑和废泥浆进行固化处理,优选配方(水泥+粉煤灰+添加剂)进行固化处理;同时考查了钻屑、钻井液固化填埋后对周围环境的影响。
2.
A simple laboratory testing method is established,and by means of this method mechanical bond strength is tested between drilling cutting and oilwell cement rock.
在实验室内，模拟水泥环与地层胶结全过程，分析了泥饼以及采用不同配方的水泥浆，对各种钻屑与油井水泥胶结强度的影响。
3.
In this thesis,several kinds of solidification agent have been screened by a lot of experiments,which are suitable for drilling cutting and waste drilling mud with high density(ρ>2.
通过大量实验研究,筛选出了分别适合于钻屑与高密度(ρ>2。
6) drilling cuttings
钻屑
1.
Durand formula,critical flow rate increased with the increase of the granularity of wellhead drilling cuttings and the volume concentration of liquid discharged when the structure of equipments were determined.
Durand临界流速计算公式分析得出,在设备结构确定以后,排料临界流速随着井口钻屑粒径、排料流体体积分数的增加而增加。
2.
A new machine of medel GZS7 is invented to convey the drilling cuttings.
采用逐点张力法对钻屑输送机所用链条各部位的受力情况进行了分析，给出了钻屑输送机所用链条的张力计算公式，为校核链条的强度及计算钻屑输送机所需功率提供了依据。
补充资料：硫酸化的动物油脂与含甘油酯的油和牛脚油钠盐
CAS：61788-70-3
中文名称：硫酸化的动物油脂与含甘油酯的油和牛脚油钠盐
英文名称：Fats and glyceridic oils, neat's-foot, sulfated, sodium salts；Neatsfoot oil, sulfated, sodium salt；Neat's foot oil, sulfated, sodium salt；Sulfated neatsfoot oil sodium salt；Sulfated neatsfoot oil, sodium salt；oils, neat's-foot, sulfated, sodium salts；Fats and glyceridic oils,neat's-foot,sulfated,sodium salts；Neatsfoot oil,sulfated,sodium salt；Neat's foot oil,sulfated,sodium salt；Sulfated neatsfoot oil,sodium salt
中文名称：硫酸化的动物油脂与含甘油酯的油和牛脚油钠盐
英文名称：Fats and glyceridic oils, neat's-foot, sulfated, sodium salts；Neatsfoot oil, sulfated, sodium salt；Neat's foot oil, sulfated, sodium salt；Sulfated neatsfoot oil sodium salt；Sulfated neatsfoot oil, sodium salt；oils, neat's-foot, sulfated, sodium salts；Fats and glyceridic oils,neat's-foot,sulfated,sodium salts；Neatsfoot oil,sulfated,sodium salt；Neat's foot oil,sulfated,sodium salt；Sulfated neatsfoot oil,sodium salt
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条