1)  butyl acetate
丁酯
2)  butylacetate
醋酸丁酯
1.
Recovery of dimethylbenzene/butylacetate from spent solvent oil by batch distillation;
基于间歇精馏回收废溶剂中二甲苯/醋酸丁酯
2.
Separating dimethylbenzene and butylacetate from the industrial waste solvents oil;
废溶剂油中二甲苯/醋酸丁酯分离研究
3.
The recovery of dimethylbenzene and butylacetate from industry spent solvent oil by conventional batch distillation and hetegeneous azeotropic batch distillation was studied, and the batch distillation experiment was performed with pretreated material.
研究采用常规间歇精馏和非均相共沸间歇精馏技术从工业废溶剂油中回收二甲苯和醋酸丁酯,对预处理后的原料进行了工艺实验研究,考察了分离温度、时间、回流比等操作参数对分离过程的影响,结果表明:采用常规间歇精馏在适宜的工艺条件下,二甲苯和醋酸丁酯在馏出液中的含量均达到95%以上,收率分别达到62%和99。
3)  butyl acetate
醋酸丁酯
1.
The butyl acetate enriching iodimetry method of determining gold′s content;
醋酸丁酯富集碘量法快速测定金
2.
A Study on Adsorption Characteristics of Butyl Acetate on Activated Carbon Fiber from Aqueous Solution;
活性炭纤维对水溶液中醋酸丁酯的吸附性能研究
3.
Azeotropic distillation of acetic acid,water and butyl acetate was simulated with the software PRO/II.
利用PRO/II软件对醋酸-水-醋酸丁酯体系的共沸精馏进行模拟计算,用Hayden-O’Connell方程计算气相逸度系数,用NRTL方程计算液相活度系数。
4)  butyl acetate
乙酸丁酯
1.
Synthesis of ammonium ferric hydrogen phosphate by solid state reaction at low temperature and its catalysis to butyl acetate;
磷酸氢铁铵的低热固相合成及其对乙酸丁酯的催化作用
2.
Analytical Conditions of Toluene and Butyl Acetate in Gas Chromatography;
气相色谱法分析甲苯和乙酸丁酯的条件探讨
3.
Preparation of NH4ZrH(PO_4)_2·H_2O via solid-state reaction at low heat and study on catalytic synthesis of butyl acetate;
磷酸钛铵的低热固相合成及其催化合成乙酸丁酯的研究
5)  tetrabutyl titanate
钛酸丁酯
1.
The emulsion PS (polystyrene) particles were immersed and swelled in the mixed medium of benzene/absolute alcohol/tetrabutyl titanate(BEN/AAL/Ti(OBu)_4)to imbibe the Ti(OBu)_4 inside the PS particles.
将乳液聚合形成的聚苯乙烯乳胶粒子在苯/无水乙醇/钛酸丁酯的混合液中溶胀,使钛酸丁酯在溶胀吸附过程中进入乳胶粒内部,以构制复合乳胶粒子,并用红外光谱、透射电镜和差热分析等方法对复合乳胶粒子的组成、形貌、热稳定性和热转变进行了研究。
2.
Nano-TiO 2 and TiO 2/SiO 2 nanocomposite heve been prepared in water solution or hydrothermal method and as substitutes for tetrabutyl titanate to catalyze PBT polymerization.
用溶胶 -凝胶法制备 Ti O2 及 Ti O2 /Si O2 复合纳米材料 ,作为 PBT(聚对苯二甲酸丁二酯 )合成的催化剂 ,与现在普遍使用的催化剂钛酸丁酯进行了比较和研究。
3.
The gelation time was reduced greatly by adding tetrabutyl titanate.
若以常用的硅酸乙酯代替钛酸丁酯，则胶凝时间明显延长，最终产物为β和α氧化铁的混晶相（γ－Ｆｅ２Ｏ３为主晶相），晶粒尺寸约为１０ｎｍ，并从中提出了一条改进γ－Ｆｅ２Ｏ３基气敏材料性能的新思路。
6)  butyl propionate
丙酸丁酯
1.
Synthesis of butyl propionate catalyzed by cerium sulfate supported on solica gel;
硅胶固载硫酸铈催化合成丙酸丁酯
2.
By using ceric sulfate as the catalyst, propanoic acid and butyl alcohol reacted to form butyl propionate.
采用硫酸铈为催化剂合成丙酸丁酯,考察了催化剂用量、醇酸物质的量比、反应时间及催化剂重复使用次数等因素对收率的影响。
3.
By using potassium bisulfate as the catalyst, propanoic acid and butyl alcohol reacted to form butyl propionate.
采用硫酸氢钾为催化剂合成丙酸丁酯,考察了催化剂用量、醇酸物质的量比、反应时间及催化剂重复使用次数等因素对收率的影响。
参考词条
补充资料：(1S)-1-(2R)-环氧乙基-2-苯乙基氨基甲酸叔丁酯
分子式：C15H21NO3
分子量：263.34
CAS号：98760-08-8

性质：

说明：补充资料仅用于学习参考，请勿用于其它任何用途。