1) anti-gassing property
抗析气性
1.
It's developed via high-pressure hydro-treating and acid-alkali washing combined with clay contact process by using atmospheric side cut and furfural extraction oil of Karamay thick oil,and adding ideal components which improve anti-gassing property.
利用适宜的克拉玛依稠油馏分经过高压加氢与酸碱精制工艺的有机结合 ,加入精制、有效的抗析气性理想组分 ,研制成功符合ASTMD3478(Ⅰ )标准的变压器油 ,研制产品的抗氧化性、抗析气性以及电气性能与进口米纳斯变压器油质量相
2) anti-segregating
抗离析性
1.
Flowability,passing ability and anti-segregating are required from a Self Compacting Concrete(SCC) in the fresh state,so it is not only a highly flowable nature but also a good consistency that SCC should have.
自密实混凝土不但要求有较大的流动性,而且还要求有较好的粘聚性,因而其施工工作性要同时具备流动性、抗离析性、和间隙通过性。
3) segregation capability
抗离析性
1.
The segregation capability is judged by the layering degree,the layering degree is calculated by 3 methods,including the density difference,the coarse aggregate mass difference and the difference of compressive strength molding by that between roof and bottom.
为减少泵送高强轻骨料混凝土在振捣过程中轻骨料的上浮现象,使用5种不同轻骨料,选择了拌和物密度、粗骨料质量以及抗压强度3种评价拌合物抗振捣分离性指标,系统研究了轻骨料体积含量、振捣时间、轻骨料特性(包括外形、表面光滑度、吸水率)和矿物掺和料以及外加剂对低水胶比的泵送高强轻骨料混凝土抗离析性的影响。
2.
The segregation capability is judged by the layering degree,the layering degree is calculated by the density difference and the coarse aggregate mass difference between roof and bottom.
为减少泵送高强轻骨料混凝土在振捣过程中轻骨料的上浮现象,使用5种不同轻骨料,根据混凝土拌合物振捣后的上、下层拌合物密度差异和粗骨料质量差异计算分层度,作为评价拌合物抗振捣分离性指标,对比轻骨料混凝土与普通混凝土的抗离析性,并研究轻骨料体积含量、振捣时间和轻骨料特性(包括外形、表面光滑度、吸水率)对低水胶比的泵送高强轻骨料混凝土抗离析性的影响。
4) resistance analysis
抗性分析
1.
A preliminary screen and resistance analysis of turned wild rice materials;
转野生稻抗稻瘟病材料初步筛选和抗性分析
5) gas anti-permeability
抗气渗性
1.
The gas anti-permeability and carbonation resistance of recycled concrete,which was prepared by using waste concrete as recycled coarse aggregate(RCA) and some cement and mineral additions as raw materials,were studied.
对再生混凝土的抗气渗性和抗碳化性能进行了研究,试验结果表明:再生混凝土的抗气渗性和抗碳化性能之间具有一定的相关性,但该两者均较普通混凝土差。
6) Resistance to controlled atmosphere (CA)
抗气调性
补充资料：抗污气性
分子式：
CAS号：
性质：一般是指以桐油为原料制成的油漆，因熬炼不当，施工后在干燥过程中接触到有害气体(如SO2，CO，NO等)时，漆膜将产生晶纹、裂纹及倒光等缺陷。抵抗发生这种现象的能力就谓之抗污气性。试验方法是将未干的样板放人玻璃罩内，罩内点燃煤油灯作为污气源。经一定时间后，检查漆膜有无出现异常现象。
CAS号：
性质：一般是指以桐油为原料制成的油漆，因熬炼不当，施工后在干燥过程中接触到有害气体(如SO2，CO，NO等)时，漆膜将产生晶纹、裂纹及倒光等缺陷。抵抗发生这种现象的能力就谓之抗污气性。试验方法是将未干的样板放人玻璃罩内，罩内点燃煤油灯作为污气源。经一定时间后，检查漆膜有无出现异常现象。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条