1) brazing foil
钎焊箔
1.
The relation between the finished product clad δi and the initial clad rate δ of sandwich brazing foil LQ3-1 is studied.
结合工厂实际生产，研究了复合钎焊箔ＬＱ３－１的原始包覆率δ与成品包覆率δｉ的关系，得出δｉ＝０。
2) brazing foil
钎焊箔材
1.
The effect of finishing rolling ratio,softening annealing temperature and grain size on the 4004/ 3003/4004 aluminum alloy brazing foil is studied in this paper.
结果表明:铝复合钎焊箔材的抗下垂性能与成品轧制前的软化退火温度以及成品轧制率有关;随着轧制率的升高,钎焊箔材的抗下垂性能的下垂值呈增加的趋势;冷加工率在10%～20%之间的钎焊箔材的抗下垂性能表现最好;进一步分析可知,箔材的晶粒度与其抗下垂性能有很直接的关系。
3) brazing aluminium foil
钎焊铝箔
1.
Effect of annealing process on sagging resistance ability of brazing aluminium foil
退火工艺对钎焊铝箔抗下垂能力的影响
4) composite brazing aluminum foil
复合钎焊铝箔
1.
The composite brazing aluminum foil,with Al -Mn alloy as its cove material and covered with10%thickness of Al-Si alloy on its two sides,is fabricated by hot-rolling method and has excellent comprehensive performances,40%weight saving can be obtained compared with those products by copper foil.
采用以Al-Mn合金为芯材,双面包覆厚度为10%的Al-Si合金钎料,采用热轧工艺轧制复合而成的复合钎焊铝箔具有优异的综合性能,质量比铜箔制的同类产品约轻40%,具有十分广阔的应用前景。
5) aluminum alloy brazing sheet(foil)
铝合金钎焊板(箔)
6) Solder strip
钎料箔
补充资料：箔条干扰火箭(见箔条投放装置)
箔条干扰火箭(见箔条投放装置)
chaff jamming rocket
botiao gQnrao huolian箔条干扰火箭(eha拜Jamming:ocket)见箔条投放装置。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条