1) additive orientation
有序添加角度
1.
Reinforcing effect of orderly additive orientation of SiC-whisker in Si_3N_4 ceramic matrix;
SiC晶须有序添加角度对Si_3N_4基体陶瓷的增韧效应
2) adding order
添加顺序
1.
Mix the foam asphalt mixture on the condition of different cement content and adding order,do splitting strength test and analyze the influence of the cement addition on its moisture sensitivity.
在水泥的不同掺量和不同添加顺序的条件下分别拌和泡沫沥青混合料,并进行劈裂强度试验,分析水泥的添加对其水稳定性的影响。
4) finite angle stack
有限角度叠加
1.
In accordance with the characteristics of raw data,the authors studied tomography,tube wave attenuation,VSP-CDP and finite angle stack,and completed the cross-well se.
针对原始资料特点,研究了以层析成像、管波衰减、VSP-CDP技术和有限角度叠加成像等关键处理技术,较好地完成了该区块的井间地震资料处理。
5) organic additives
有机添加剂
1.
Actions of certain organic additives on Cu-Zn alloy electrodeposition from sulfate-tartrate solutions;
某些有机添加剂对硫酸-酒石酸盐溶液中电沉积Cu-Zn合金的作用(英文)
2.
Effect of organic additives on the performance of sealed lead-acid batteries;
有机添加剂对密封铅酸蓄电池电性能的影响
3.
Effect of organic additives on porous silicon nitride ceramics prepared by extrusion method
有机添加剂对多孔氮化硅陶瓷挤出成型工艺的影响
6) organic additive
有机添加剂
1.
Effect of organic additive on performance of zinc electrode in electrolyte;
电解液中有机添加剂对锌电极性能的影响
2.
Effects of organic additives and elemental sulphur applied to soils on the growth and nutrient absorption of Brassica chinensis;
土施有机添加剂和硫磺对小白菜生长和养分吸收的影响
3.
Influence of organic additives on the corrosion resistance of aluminum tube with silane coating
有机添加剂对铝管表面硅烷涂层耐蚀性的影响
补充资料：Anglelapping角度研磨
angle lapping 的目的是为了测量junction的深度，所作的芯片前处理，这种采用光线干涉测量的方法就称之angle lapping。公式为xj=λ/2 nf即junction深度等于入射光波长的一半与干涉条纹数之乘积。但渐渐的随着vlsi组件的缩小，准确度及精密度都无法因应。如srp(spreading resistance prqbing)也是应用angle lapping的方法作前处理，采用的方法是以表面植入浓度与阻值的对应关系求出junction的深度，精确度远超过入射光干涉法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条