1)  sunk angle
塌角
1.
The cause of sunk angles in processing a part by wire cutting was analyzed.
分析了线切割加工中塌角形成的原因 ,并介绍了防止塌角的对策 ,可供同行参
2)  collapse angle
坍塌角
3)  gear crest point cave in
齿尖塌角
4)  sunk volume
塌角量
5)  edge flaw
边缘塌角
1.
This paper presents a measurement method of edge flaw on metal workpiece base on measurement way of chain elements flaw, taking a laser as light resource, CCD as receiving component, and a single chip microprocessor as data processing system.
文章以链片塌角的测量方法为例提出了一种金属工件边缘塌角的测量方法。
补充资料：光塌塌
1.光秃貌;空荡无存貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。