1) vertical roller
立轧辊
1.
Using three dimensional elastic contact finite element method, the contact stress between the vertical roller shaft and the hole of vertical roller chock in universal mill is analysed.
采用三维弹性接触有限元法对万能钢梁轧机立轧辊轴与轴承座之间的接触应力进行了分析,得出了接触应力的三维分布、最大值以及接触应力随轴承座孔承载厚度变化的规律,并找到了确定轴承座孔最小可行承载厚度的方法。
2) slab edging
立轧
1.
There occurs heavy fish tail and width shortage around the head and tail ends of the slab resulted from unsteady state deformation during slab edging with flat cylindrical roll in roughing stands of hot strip mill.
采用全３ 维刚塑性有限元法对热带粗轧机组平辊立轧非稳态过程进行了分析和比较，所得到的轧件形状、轧制力及轧制力矩与文献的实验结果吻合较好，计算精度比文献的理论结果有所提高·表明全３ 维模型具有明显的优越性，同时所采用的处理轧件入口处奇异点的方法是有效的
3) V rolling
平辊立轧
1.
Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method,the effection of V rolling and chamfer rolling on the plate profile is analyzed.
基于中厚板无切边轧制法中立轧轧边变形的物理模拟,分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。
2.
Based on physical simulation of edge rolling process,the article analyzed the effection of V rolling and chamfer rolling on the plate profile.
基于中厚板在立轧轧边后板坯变形的物理模拟,分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。
4) edge rolling
板坯立轧
5) caliber edging
孔型立轧
1.
In this paper, an analysis to caliber edging was carried out by full 3D rigid plastic FEM.
采用三维刚塑性有限元法对2S-Al板孔型立轧稳态过程进行了分析和比较,所得轧件断面形状、轧制力及轧制力矩与文献[1]的实验结果吻合很好,计算精度有所提高。
6) edging pass
立轧孔
1.
The piece can t be kept stable when it enter the edging pass from horizontal pass by traditional pass design method of K_3 to select the circular radium R.
按传统立轧K_3孔的设计方法选取椭圆半径R值,平孔轧件进入立轧孔时轧件不易保持稳定,通过分析和实践得出,椭圆半径R的取值范围应为:H_K/2>R>R_(min)。
参考词条
补充资料：邢台机械轧辊(集团)有限公司大型铸铁轧辊的浇注
邢台机械轧辊(集团)有限公司大型铸铁轧辊的浇注
邢台机械轧辊(集团)有限公司大型 铸铁轧辊的浇注
说明：补充资料仅用于学习参考，请勿用于其它任何用途。