1) horizontal rolling
平轧
1.
A simulation for steady deformation of 2S Al slabs during edging and horizontal rolling was done by full 3D rigid plastic FEM.
用全三维刚塑性有限元法分析了2SAl板坯立轧和随后平轧的稳定轧制过程。
2) flat rolling
平辊轧制
1.
Lateral spreading deformation behavior in flat rolling of copper cladding aluminum composite rods
铜包铝复合棒材平辊轧制宽展变形行为
2.
Deformation during flat rolling is dissussed.
提出了用上限法分析稳态塑性变形问题的一般方法，用双流超几何函数法导出了通用的运行许可速度场的数学表达式，并对平辊轧制问题进行了讨论
3.
The deformation behaviour of copper cladding aluminum wire in flat rolling process was investigated.
采用三维刚塑性有限元法,研究铜包铝复合线材由圆断面到扁断面的平辊轧制变形行为及其对主要工艺参数的影响,并对模拟结果进行实验验证。
3) V rolling
平辊立轧
1.
Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method,the effection of V rolling and chamfer rolling on the plate profile is analyzed.
基于中厚板无切边轧制法中立轧轧边变形的物理模拟,分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。
2.
Based on physical simulation of edge rolling process,the article analyzed the effection of V rolling and chamfer rolling on the plate profile.
基于中厚板在立轧轧边后板坯变形的物理模拟,分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。
4) flat rolled products
平轧产品
5) hot rolled plates
热轧平板
6) roll balance
轧辊平衡
1.
Improvement of hydraulic circuit of roll balance system;
轧辊平衡液压控制回路的改进
补充资料：轧平
轧平
没有多头也没有空头，即相当於持平或者轧平。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条