1) ?average area of wear land
磨损带面积
2) the area ratio ofthe grit wear area
磨粒磨损平面面积率
3) Posterior molar with large defect
大面积缺损磨牙
4) major flank wear land
后刀面磨损带
1.
The area of the major flank wear land ( A B ) is presented as an index estimating milling cutter wear out.
鉴于后刀面磨损带面积 (AB)可以作为衡量刀具磨损程度的一个指标 ,以此为据建立了作用在小直径螺旋立铣刀后刀面瞬时切削力和平均切削力与AB 间的数学模型 。
5) wear volume
磨损体积
1.
The relationships between the amounts of graphite addition and graphite eutectoid,voltage and graphite eutectoid amount,graphite addition amount and microhardness,and graphite addition amount and wear volume were discussed.
采用电刷镀技术制备了N i-石墨颗粒复合镀层,给出了N i-石墨复合电刷镀的工艺流程和镀液配方,讨论了石墨添加量与石墨共析量、电压与石墨共析量、石墨添加量与显微硬度、石墨添加量与磨损体积之间的关系。
2.
The effects of normal load,vibration amplitude and frequency on friction coefficient and wear volume were analyzed.
利用微动磨损试验机研究7A52铝合金的微动磨损行为,分析不同载荷、振幅、循环次数等参数对摩擦因数和磨损体积的影响,观察分析不同振幅下的磨痕形貌,检测磨痕微区及磨粒的成分组成,探讨其磨损机制。
6) wear cumulation
磨损累积
1.
With theoretical analysis and experimental research, the regularity of wear cumulation of carbide tools under varying cutting speed conditions is studied .
通过理论分析和试验研究,探讨硬质合金刀具在变速切削条件下磨损累积的规律。
补充资料：板带轧制速度规程(见板带轧制规程设计)
板带轧制速度规程(见板带轧制规程设计)
speed schedule for plate and strip rolling
bandai zhazhi sudu guieheng板带轧制速度规程(speed seheduxe fo:plateand strip rolling)见板带札制规程设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条