1) soldering
钎着
2) brazing rate
钎着率
1.
The paper formulates that seam strength of contact is not only relevant to brazing rate but is also affected by microstructure of brazing seam When the brazing rate is over 75%, the brazing strength of contact will decrease with the increase in eutectic structure in brazing sea
提出了触头的钎焊强度不仅与钎着率有关 ,而且还受钎缝组织形态影响。
2.
This paper presents a systematic research into the induction brazing technology of Ag-CdO Contact to Cu bridge and an analysis of the influences of brazing temperature, holding time and joint gap on the brazing rate, microstructure and mechanical properties and discusses the best technological parameters for good brazing rate and good microstructure.
分析了钎焊温度、保温时间、钎焊间隙对钎着率、组织形态和力学性能的影响规律，并确定了钎着率和组织形态均为良好的最佳工艺规范。
3) brazed rate
钎着率
1.
The brazed rate is an important parameter represented product quality.
钎着率是判断钎焊质量的重要指标。
2.
A kind of UT image NDT and evaluation technique,and the calculation method for brazed rate are introduced in the present paper.
由于钎焊接头很窄,常规无损检测方法难以适应,本文介绍一种钎焊接头超声成像无损检测与评价的技术, 以及钎着率的计算方法。
补充资料：吃着碟子看着碗
1.比喻贪心不足。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。