1) technology of the CAM PI
斜冲孔工艺
2) punching hole
预冲工艺孔
1.
The paper studies the parameters affecting the forming of sheet with punching hole by simulation software and orthogonal experiment,and concludes the law of the parameters affecting the forming.
利用模拟软件,运用正交试验法对影响预冲工艺孔板料成形性能的参数进行研究,得出各参数对该情况下成形性能影响程度的规律。
3) side panel piercing technology
侧壁冲孔工艺
4) impact-shock hole forming technology
冲击成孔工艺
1.
According to the detail description on one project geological condition,it analyzes the test result of its single pile vertical anti-pressure statistic loading,results prove that the pile loading resulted from site rotary hole forming is obviously lower than pile resulted from impact-shock hole forming,thus improving application of the impact-shock hole forming technology.
通过对某工程地质条件的详细概述,就其单桩竖向抗压静载试验结果作了分析,结果表明,场地回转成孔工艺所成桩的承载力明显低于冲击成孔所成的桩,进而推广冲击成孔工艺的应用。
5) punched cast-in situ technique
冲孔灌注桩工艺
6) slant_surface piercing
斜面冲孔
1.
The main points for designing the multi_hole piercing die and the slant_surface piercing die were stated.
介绍了防护板的结构特点 ,多孔冲模以及斜面冲孔模具的设计要点 ,并对斜面冲孔结构做了一定的改进 ,使模具的使用寿命和可靠性大大提高 ;加工精度的控制和保证 ,装配技术的改进 ,从而大大缩短了模具装配时间和制造周期。
补充资料：采气工艺(见天然气开采工艺)
采气工艺(见天然气开采工艺)
gas production technology
，一‘J\匕乙吕天然气开采工艺pro以uetionteehnology)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条