说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 还原期
1)  reduction phase
还原期
1.
In order to control soot pollution of reduction phase in copper refining furnace, based on technical principle of decreasing soot and combusting soot which has been made, emulsifying heavy oil,increasing emulsified oil temperature,improving mode of reductive oil,setting firebox in side flue to combust soot again are performed in soot control.
为了降低铜精炼反射炉还原期的黑烟污染 ,根据减少黑烟的生成及使黑烟通过燃烧消除的技术原理 ,选定重油乳化、提高炉前乳化油温度、改进还原重油喷入方式、在副烟道中设置燃烧室进行黑烟的二次燃烧为突破口进行了黑烟的治理。
2)  reduction periods
还原周期
1.
It can reduce the temperature of the reduction reaction, shorten the reduction periods and eliminate MgCl2 in titanium sponge by using the technology of feeding raw materials from more than one places in the large-scale reactor.
而在大型反应器中采用多点加料工艺,可以降低还原反应温度,缩短还原周期,消除夹心氯化镁的存在,为提高海绵钛的产量和质量,提供了一条切实可行的生产途径。
3)  reduction cycle,reduction period
还原期<冶>
4)  cancellation of reduction period
取消还原期
1.
After having analyzed the composition control and steel quality with cancelling reduction period, it is considered that,if operation process is normal, cancellation of reduction period can not only reduce smelting time and the power consumption, but alos decrease gas content in steel.
介绍碱性电弧炉冶炼20Must取消还原期的工艺操作要点。
5)  Reduction to Dated Quantities of Labor
还原为有时期的劳动量
6)  NO reduction
NO还原
1.
Effects of reducing agents on NO reduction over Ag/Al_2O_3 catalyst;
还原剂对Ag/Al_2O_3催化剂上NO还原的影响
2.
The results showed that NO reduction and NO oxidation.
结果表明:NO还原和氧化在其脱除过程中同时共存,当NO,N2,O2,H2O和CO2的体积浓度分别为200×10-6,80%,5%,6%和9%时,NO氧化所占的比例比NO还原的大很多;脉冲频率增大导致NO还原率和氧化率均增大;H2O浓度增大导致HNO3浓度增大,表明NO氧化所占的比例随H2O浓度增大而增大。
3.
Combustion experiments on Shenmu bituminous coal and Geliping blind coal were carried out in a high-temperature horizontal twin-tube quartz stove,and NO volume fraction was measured in real-time during the combustion to investigate the effect of magnesium acetate on NO reduction.
实验结果表明,醋酸镁对燃料型NO生成的还原作用受到煤种、燃烧温度和燃烧气氛的影响,NO还原率可达23%。
补充资料:还原期

reductionperiod:普通功率电弧炉炼钢操作中,通常把氧化末期扒渣完毕到出钢这段时间称为还原期。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条