1) Critical explosive dosage
临界药量
2) critical blasting charge
临界装药量
3) critical flux
临界通量
1.
Study on effect of membrane fiber length on critical flux in a novel membrane bioreactor;
新型膜-生物反应器中膜丝长度对临界通量的影响
2.
Study of critical flux in flat-sheet membrane bioreactors;
平板膜生物反应器临界通量测定方法研究
3.
Factors affecting critical flux in submerged flat membrane bioreactor;
影响一体式平板膜生物反应器临界通量的因素
4) Critical output
临界产量
1.
Through analyzing the effect of the vertical locations of horizontal wells on the critical output and gas breakthrough time of the gas cap reservoir, the curve showing the relationship between the vertical locations of horizontal wells and the critical output as well as the gas breakthrough time is obtained in t.
针对这一问题,从水平井垂向位置对气顶油藏临界产量和见气时间的影响入手,得出了临界产量和见气时间与水平井垂向位置的关系曲线;在综合考虑临界产量和见气时间的基础上,得到了水平井垂向位置与临界产量和见气时间乘积的关系曲线,由曲线趋势得到了气顶油藏水平井最优垂向位置的范围。
2.
The bottom water coning model used by Boyun Guo considered the influence of perforation length on critical output, so it can be used to calculate the perforation length of bottom water reservoir.
由于BoyunGuo等人使用的底水锥进模型引入了射孔长度对临界产量的影响,所以可用于优化底水油藏的射孔段长度。
3.
The paper has discussed the effect of vertical locations of horizontal wells on the critical output and producing pure oil time,analyzed the ratio .
水平井垂向位置与临界产量、产纯油时间、油水密度差和油气密度差比值,以及临界产量与产纯油时间的乘积等关系的研究结果表明,水平井垂向位置越靠近气顶或底水,临界产量越高,但产纯油时间越短;越靠近最佳位置(气水同时锥进到油井中),临界产量越低,产纯油时间越长。
5) threshold quantity
临界量
1.
Analysis of difference in threshold quantity for identification of major hazard installations between domestic and aboard;
浅析国内外重大危险源辨识中危险物质临界量的差异
2.
Under our country background, the standard of Identification of major hazard installations was revised in application scope, the classification of major hazard installations, the category of dangerous substance, threshold quantity of unit, and so on.
本文对国外发达国家重大危险源辨识标准现状进行了调研,结合我国实际情况,提出了《重大危险源辨识》适用范围、分类、危险物质种类及临界量等方面的修订建议,解决了以前重大危险源申报登记工作中存在的一些技术性问题,可作为我国中长期重大危险源监督工作的指导性文件和重大危险源监管体系建设的依据。
3.
Based on the threshold quantity of Identification of major hazard installations in "Identification of major hazard in-stallations",it makes out the hazardous chemicals catalog and their threshold quantity suitable for China, and offers some suggestion of implementing process safety management in China.
从工艺安全管理(PSM)的角度,对美国、欧盟等的工艺安全管理系统适用范围的定义进行分析,结合目前国内《重大危险源辨识》中给出的部分危险化学品的临界量,以此为基础制定适合我国国情的危险化学品目录并确定各物质的临界量,提出在我国推行工艺安全管理系统的建议。
6) critical production rate
临界产量
1.
Calculation method of critical production rate for fractured-vuggy reservoir with bottom water
塔河油田缝洞型底水油藏临界产量计算研究
2.
In 1993, a formula for critical production rate of oil well in bottom water reservoir with partition board was proposed by Dr.
1993年李传亮提出的带隔板底水油藏油井临界产量的计算公式中不含油井打开程度的参数,即没有考虑油井打开厚度的影响。
3.
On the basis of this theoretic model, the critical production rate, the shape of water coning and the optimum perforation intervals could .
在理论模型的基础上,建立了预测临界产量、水锥形态以及优化射孔长度的数学模型。
补充资料:极限药量
分子式:
CAS号:
性质:又称最小起爆药量(minimum primary charge)。在一定试验条件下,使猛炸药完全爆轰所需最小起爆药量。用以衡量猛炸药的起爆感度和起爆药的起爆能力。测定时,将1g猛炸药压入雷管壳底,再将不同量的起爆药压入雷管,然后以导火索引爆,观察猛炸药是否完全爆轰,并找出能引起爆轰的最小起爆药量。
CAS号:
性质:又称最小起爆药量(minimum primary charge)。在一定试验条件下,使猛炸药完全爆轰所需最小起爆药量。用以衡量猛炸药的起爆感度和起爆药的起爆能力。测定时,将1g猛炸药压入雷管壳底,再将不同量的起爆药压入雷管,然后以导火索引爆,观察猛炸药是否完全爆轰,并找出能引起爆轰的最小起爆药量。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条