1) smectic PP
次晶PP
2) high crystalline PP
高结晶PP
1.
The effects of different compatibilizers on mechanical properties of high crystalline PP/GF were also investigated.
考察了玻璃纤维(GF)增强高结晶聚丙烯(PP)的力学性能,发现高结晶PP/GF的力学性能较普通PP/GF的提高15%～18%;同时考察了不同增容剂对高结晶PP/GF的力学性能的影响,均聚接枝物拉伸强度、弯曲强度较高,共聚接枝物的冲击强度较高;另外发现在PP/GF中加入山梨醇型α成核剂、芳酰胺类β成核剂后,两者对其性能有较大影响,使其力学性能降低40%以上。
3) polypropylene
[英][,pɔli'prəʊpəli:n] [美]['pɑlɪ'propə'lin]
PP
1.
Formulating of Recipe of β Crystal Form Nucleation of Polypropylene Resin;
PP树脂β晶型成核配方设计
2.
The nanocomposites composed of polypropylene(PP),ethylene-propylene-diene terpolymer(EPDM) and nano-Mg(OH)2 particles were prepared by melt blend dynamic vulcanization method.
采用动态硫化法制备了聚丙烯/三元乙丙橡胶/纳米Mg(OH)2复合材料,通过力学性能测试、差示扫描量热仪(DSC)分析等手段,对纳米氢氧化镁填充EPDM/PP的力学性能以及结晶与熔融特征进行了研究,通过透射电镜考察了纳米Mg(OH)2在EPDM/PP体系中的微观结构。
4) decagonal quasicrystal
十次准晶
1.
Structural features of several different modifications of Al-Co-Ni decagonal quasicrystals revealed by HAADF-STEM technique;
Al-Co-Ni十次准晶中几种变体结构的HAADF研究
5) secondary crystallization
二次结晶
6) secondary dendrite
二次枝晶
1.
Study on modeling of solute concentration distribution in secondary dendrite during solidification of molten steel
钢凝固过程中二次枝晶间溶质分布的模型研究
2.
The effect of nitrogen on the secondary dendrite of primary austenite of Fe-C-Si and Fe-C-Si-Mn grey cast irons was studied through unidirectional solidification.
采用单向凝固方法研究了氮对Ｆｅ－Ｃ－Ｓｉ和Ｆｅ－Ｃ－Ｓｉ－Ｍｎ灰铸铁初生奥氏体二次枝晶组织的影响。
3.
The results show that under the condition of industrial casting furnace,with the increase of withdrawal rate,the element segregation decrease,the primary dendrite and secondary dendrite arm spacing reduce,the size of the as-cast γ′ precipitates shorten.
研究结果表明：在工业生产炉条件下,随抽拉速率的增加,合金元素偏析减小,树枝晶一次及二次枝晶臂距减小,铸态γ′相尺寸逐渐变小。
补充资料：A1-Cu-Co合金中十次对称准晶单晶体及其衍射图
A1-Cu-Co合金中十次对称准晶单晶体及其衍射图
‘ Al Cu—Co合金中十次对称准晶堕晶体e1)及其衍射圈(z) 中国科学盹垒禹研览听供稿
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条