1) dynamic tensile strength
动态拉伸强度
1.
A new experimental method was developed to measure the dynamic tensile strength of fragile tungsten alloys.
针对易碎型钨合金具有高的动态压缩强度和低的动态拉伸强度这一特点 ,根据一维应力波理论设计一种测试易碎合金动态拉伸强度的实验方法 。
2.
With finite element analysis,dynamic tensile strength for marble was obtained and typical failure modes of the Brazilian disc and the flattened Brazilian disc were analyzed.
结果表明,大理岩的动态拉伸强度随着应变率的提高而增加。
3.
An experimental procedure and accompanying method for analyzing recorded data for deriving dynamic tensile strength and elastic modulus of brittle material is presented.
提出了获取脆性材料动态拉伸强度及弹性模量的实验步骤及相关记录数据的分析方法。
2) dry strength
干态拉伸强度
3) hot tensile strength
热态拉伸强度
4) tensile strength
拉伸强度
1.
Influence of microstructure on phase transformation and tensile strength of hot-rolled TN479 shape memory alloy rod;
TN479形状记忆合金棒材显微组织对相转变和拉伸强度的影响
2.
The assessment of measurement uncertainty in the tensile strength tests on metal specimen;
金属试件拉伸强度试验测量不确定度的评定
3.
Effect of fiber surface treatment on tensile strength of C/SiC composites;
纤维表面处理对单向C/SiC复合材料拉伸强度的影响
5) tension strength
拉伸强度
1.
Study on the biaxial tension strength of pebble concrete and gravelly concrete;
碎石混凝土与卵石混凝土双向拉伸强度研究
2.
The experiment compare of carbon cloth s tension strength with and without glue indicates that the epoxy resin can not only make the fiber adhesive united but also increase the tensile strength.
对比有胶与无胶纤维布拉伸实验,表明环氧树脂不仅粘接纤维布,对纤维布有保护作用,而且能够显著提高其拉伸强度。
3.
The change of the tension strength and the rupture elongating rate with different loading rates and ultraviolet radiation exposure time was measured and analyzed.
研究了人工模拟紫外线照射条件下软包装复合材料(BOPET/AL/LDPE)拉伸性能的变化情况;分析了不同加载速率和紫外线照射时间下,复合材拉伸强度和伸长率的变化规律。
6) dynamic tension
动态拉伸
1.
Experimental studies on dynamic tension of metal ring by electromagnetic loading;
实现金属环动态拉伸的电磁加载技术研究
2.
The mechanisms of crack forming and propagation were investigated during dynamic tension under static load by SEM.
采用熔铸法制备的原位自生TiC/Ti复合材料,在SEM中静载动态拉伸,原位观察和研究了裂纹的萌生及扩展机制。
3.
The dynamic tensile properties of tungsten fibers(80%,volume fraction) reinforced Zr based amorphous alloy matrix composite was investigated by means of the Split Hopkinson Pressure Bar(SHPB),and Scanning Election Microscope(SEM) was used to evaluate the fracture mode of the composite under dynamic tension.
采用霍普金森杆拉伸技术研究了W丝体积分数为80%的W丝/Zr基非晶合金复合材料的动态拉伸性能,通过扫描电镜研究了该复合材料动态拉伸断裂模式。
补充资料：拉伸强度
分子式：
CAS号：
性质：又称抗拉强度，抗张强度，扯断强度。符号σb。材料或构件受拉力时抵抗破坏的能力。可用强度极限来表示。金属和非金属材料的机械性能的一项指标。单位为Pa[帕(斯卡)]。纸张作纵向测定或横向测定，分别称纵向拉伸力或拉伸抗张力。
CAS号：
性质：又称抗拉强度，抗张强度，扯断强度。符号σb。材料或构件受拉力时抵抗破坏的能力。可用强度极限来表示。金属和非金属材料的机械性能的一项指标。单位为Pa[帕(斯卡)]。纸张作纵向测定或横向测定，分别称纵向拉伸力或拉伸抗张力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条