1) WC rolling ring
WC辊环
1.
Causes analysis of WC rolling ring breakage used in high-speed wire rod mill and the control measures;
高线轧机WC辊环断裂分析与控制
2) WC carbide roll
WC硬质合金辊环
3) Co-WC corrugated roller
Co-WC瓦楞辊
4) tungsten carbide
WC
1.
Micro defects in tungsten carbide particulates reinforced steel matrix composites by electroslag melting and casting;
电冶熔铸WC/钢复合材料的显微缺陷
5) roll collar
辊环
1.
The effect of different amounts of K/Na-RE addition into high-speed steel(HSS) used for roll collar was investigated utilizing Hi-scope video microscope(HSVM) and mechanical property measurement.
在辊环用高速钢中添加不同含量的K/Na-RE复合变质剂,对试样分别进行HSVM及力学性能测试。
2.
A kind of high speed steel roll collar with high wear-resistance has been developed usingcentrifugal casting technique, to replace common alloy cast iron rolf collar with low wear-resistance and hard alloyroll collar with high price.
常用合金铸铁辊环耐磨性低,而硬质合金辊环成本高,采用离心铸造方法,开发了耐磨性能优良的高速钢辊环,高速钢辊环的硬度达63～65HRC,辊面硬度差小于2HRC,冲击韧性大于16J/cm~2。
3.
We research the effect of high speed steel compositions, centrifuge casting technology parameter and composite modification on the properties of high speed steel roll collar.
研究了高速钢成分、离心铸造工艺参数和复合变质处理对高速钢辊环性能的影响。
6) roll ring
辊环
1.
The application of high speed steel roll ring in the High Speed Wire Rods Plant of Tiangang Group is introduced.
介绍了高速钢辊环在天钢高线厂应用的情况,对高速钢辊环与碳化钨辊环的优缺点进行了对比,提出了高速钢材质辊环、轧辊在轧钢厂使用的可能性。
2.
The assembly designs of roll ring suffice not only for the lower limit of rolling moment,but also for the upper limit of roll ring strength.
辊环装配设计既要满足轧制力矩传动的下限条件,又受到辊环强度的上限条件限制,设计计算要求较高精度。
3.
The pressure value on the taper sleeve during fixing roll ring of cantilevered mill for high speed wire rod was calculated by analyzing the balance of force and moment of the taper sleeve So,the problems of roll collapse and loose can be avoided,which caused by large and small pressure on the taper sleev
通过对高线悬臂式轧机辊环安装固定中锥形套的受力分析 ,计算了加压工具的加压值 ,从而避免了加压过大造成崩辊 ,加压过小造成松辊的问
补充资料：辊辊
1.犹混混。形容苟且混世。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条