1) Drawing-out Repose angle
放出安息角
2) outlet installing angle of impeller
叶轮出口安放角
1.
Focusing on overload problem of motor due to higher power of great efficient impeller of some feed pumps,the paper discussed the original parameters of DG270-150 type high pressure feed pump,the relationships between the outlet installing angle of impeller and the height of feed water,the flow rate and the power by analyzing and calculating,which can make the water pump operate at power rating.
针对某些给水泵高效叶轮功率太大而出现电动机过载问题,阐述了DG270-150型高压给水泵原始参数,通过计算分析找出了叶轮出口安放角与给水高度、流量和功率的关系,能够使水泵降至额定功率运行。
3) Rest angle
安息角
1.
In this paper,the problem of the deformation of heavy dump truck′s freight container was researched,and the calculation formula of the pressure distribution on freight container′s side plate was derived by using the parameter of the rest angle and the density.
研究重型自卸车货厢胀厢问题,推导出用货物密度和安息角表示的货厢侧板压力分布计算公式,在此基础上建立典型的重型货车整体结构胀厢分析有限元模型,并进行货厢强度刚度计算。
5) angle of repose
αr 安息角
6) setting angle of vane
导叶安放角
补充资料：放出
1.释放。 2.发放或借出。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条