1) oxidation induction temperatures
起始氧化温度
1.
A prediction model of the relationship between oxidation induction temperatures and times for lubricating oils;
润滑油起始氧化温度与氧化诱导时间关系的预测模型
2) Densification starting temperature
致密化起始温度
3) initial temperature
起始温度
1.
This paper proposes that the initial temperature T i of gear is rising gradually during laser scanning tooth by tooth.
提出了齿轮激光淬火逐齿扫描时每个轮齿的“起始温度Ti”的渐变性。
2.
The impact of the initial temperature on the measurement results was also discussed.
文章通过依据不同标准所规定的测试方法进行塑料热变形温度(HDT)测量,找出测量结果之间的规律;同时研究了测量热变形温度过程中使用的硅油的黏度对测量结果的影响,提出更换硅油频率的建议;还探讨了测量起始温度对测量结果的影响。
4) oxidation onset temperature
氧化开始温度
1.
Thermogravimetric analysis(TG),melt flow rate,and oxidation onset temperature(OOT) were employed to characterize the stability of PP containing the antioxidants.
分别采用热重分析、熔体流动速率和氧化开始温度等分析方法考察了其在聚丙烯(PP)中的稳定化作用。
5) initial cooling temperature
起始冷却温度
1.
It is effective ways of improving iron oxide powder on surface of hot rolled steel sheet to lower strip’s initial cooling temperature and reduce strip’s inside and outside temperature gradient.
通过调查、统计与对比试验,分析了SN400B钢板表面氧化铁粉的成因及影响因素,指出降低带钢起始冷却温度、减少带钢内外温度梯度是改善热轧板表面氧化铁粉的有效途径。
6) Crystallization onset temperature
结晶起始温度
1.
There is a distinct increase of 10～15 ℃ in crystallization onset temperature and crystallization peak temperature compared with pure IPP.
成核后等规聚丙烯的结晶起始温度和结晶温度均提高 10～ 15℃ ,同时等规聚丙烯结晶度增加 ,晶粒细微化。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条