1) angle
[英]['æŋɡl] [美]['æŋgḷ]
角部
1.
The numerical simulation of heat transfer in the continuous casting slab angle;
连铸坯角部传热过程的数值模拟
2) corner of workpiece
轧件角部
1.
Analysis of tendency of ductile fracture at corner of workpiece during grooveless rolling;
无槽轧制轧件角部的韧性断裂趋势分析
3) transverse corner crack
角部横裂
1.
Causes and countermeasures of transverse corner crack on narrow continuous casting slab;
连铸窄板坯角部横裂的成因及对策
4) corner insulation
角部保温
1.
The production mode with high aluminum level,general molecular ratio,low electric voltage and strengthening corner insulation could overcome the negative inflence that high aluminum level brought completely.
采用高铝水平、中分子比、低电压的生产模式并加强角部保温,完全可以克服高铝水平带来的负面影响。
5) longitudinal corner crack
角部纵裂
1.
Due to frequent emergencies of bleeding out by the billet longitudinal corner crack,the characteristic and mechanism of bleeding out are analyzed.
由于方坯角部纵裂漏钢事故频繁,通过分析漏钢的特点和机理,认为造成小方坯角部纵裂漏钢的主要原因是结晶器倒锥度小、结晶器液面波动及中间包过热度大、结晶器冷却水质差。
2.
1 steelmaking plant of WISCO in 2006 have been made and the main characteristics and mechanism of sticking breakout and longitudinal corner crack induced breakout analyzed.
统计了武钢一炼钢厂方坯连铸机2006年的漏钢情况,分析了粘结漏钢和角部纵裂漏钢的特点及机理,并找出了产生粘结漏钢和角部纵裂漏钢的主要原因是保护渣的性能、结晶器的精度、钢水的过热度、拉速及浸入式水口的对中等。
6) waist obliquity
腰部倾角
1.
The fem simulation for the effect of spread on Q345B square billets rolled by adjusting waist obliquity in box pass;
箱形孔腰部倾角对轧制Q345B方坯宽展影响的有限元模拟
补充资料：输卵管子宫角部种植术
输卵管子宫角部种植术
手术名。适用于 输卵管间质部或峡部阻塞。此方法术后再通率高，但复孕率较低，足月分娩率为14%～27%， 宫外孕发生率约为3%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条