1) antiwear extreme pressure additive
抗磨极压剂
2) EP antiwear agent
极压抗磨剂
1.
The synthetic principle,technique process and evaluation on all kinds of performances of EP antiwear agent named shang309 were described.
简述了上３０９ 极压抗磨剂的合成原理、工艺路线，并对上３０９ 进行了各项性能的评定，同时将上３０９ 应用于无灰高压抗磨液压油、工业齿轮油中，得出上３０９ 具有较好的油溶性、优良的极压抗磨性、水解安定性、热稳定性等。
2.
WH525 antiwear type oil film bearing oil, composed of deeply refined Daqing 500 SN as base oil and some additives such as antioxidant, emulsion breaker, EP antiwear agent, rust inhibitor and antifoaming agent, and so on, was developed.
以大庆５００ＳＮ为原料油，经深度精制后作为基础油，添加适量的抗氧剂、破乳剂、极压抗磨剂、防锈剂和消泡剂等，研制出ＷＨ５２５抗磨型油膜轴承油，其质量指标达到ＭｏｂｉｌＶａｃｕｏｌｉｎｅ５２５油膜轴承油指标要求。
3) extreme pressure antiwear additive
极压抗磨剂
1.
The possibility of low viscosity lubricating oil containing new type extreme pressure antiwear additive was presented.
论述了摩擦磨损的机理，介绍在使用新型极压抗磨剂时，润滑油低粘化的可能性，以及在实际应用中取得的经济效益。
4) AW and EP additives
极压抗磨剂
1.
Ferrographic analysis of wear debris lubricated by various of AW and EP additives with different dosages in pentaerythritol ester on the Four-ball test is carried out.
通过对四球试验后得到的磨粒进行铁谱分析,探讨了极压抗磨剂的摩擦学特征,研究发现:TCP 的作用一般,TPPT 由于 P=S 键的引入增强了其极压抗磨性能,MBT 的效果最好,但它在高负荷下的磨损也较大,文章最后提出,这种较大的磨损是由于腐蚀磨损造成的。
5) extreme pressure and antiwear additive
极压抗磨添加剂
1.
The influences of three kinds of extreme pressure and antiwear additives(T321、TCP and T202) and their different concentrations,test temperatures and times on colloidal performance of Lithium-Calcium-based grease were studied by the centrifugal oil separation test assembly and roll stability tester.
利用离心分油试验机和滚筒试验机分别考察了3种不同的极压抗磨添加剂(T321,TCP和T202)以及其不同添加量、不同的实验温度或时间对锂-钙基润滑脂胶体性能的影响。
6) extreme pressure-antiwear additive
极压抗磨添加剂
1.
Put three kinds of extreme pressure-antiwear additives(T 304? T 321 and T 404) into four kinds of high-temperature lithium complex greases with different constituents, and observe their effect on the performances of greases.
将3种极压抗磨添加剂(T304、T321和T404)分别加入到4种不同组分的高温复合锂基润滑脂中,考察其对润滑脂性能的影响。
2.
Three kinds of extreme pressure-antiwear additives(T304,T321 and T404) were put into four kinds of lithium complex greases with different constituents,and their effect on the performances of greases was observed,and the mechanism was analyzed.
将3种极压抗磨添加剂(T304、T321和T404)分别加入到4种不同组分的复合锂基润滑脂中,考察其对润滑脂性能的影响。
补充资料：极压润滑剂极压润滑
分子式：
CAS号：
性质： 具有防止滑动面破坏的各种润滑剂称为极压润滑剂。极压润滑剂一般都含有极压添加剂。极压齿轮油、极压润滑脂、切削油、轧钢油等都含有极压润滑剂。这种润滑剂用于处在重载(或高接触应力)、高速、高温下滑动摩擦表面的润滑称为极压润滑。极压润滑通常是通过极压添加剂与金属表面生成极压膜将两摩擦表面隔开，以降低摩擦系数、减缓磨损，达到润滑的目的。
CAS号：
性质： 具有防止滑动面破坏的各种润滑剂称为极压润滑剂。极压润滑剂一般都含有极压添加剂。极压齿轮油、极压润滑脂、切削油、轧钢油等都含有极压润滑剂。这种润滑剂用于处在重载(或高接触应力)、高速、高温下滑动摩擦表面的润滑称为极压润滑。极压润滑通常是通过极压添加剂与金属表面生成极压膜将两摩擦表面隔开，以降低摩擦系数、减缓磨损，达到润滑的目的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条