1) high friction factor
高摩擦系数
1.
Study has been carried out to reduce cost, simplify process and improve and stabilize the product property according to sufficient analysis of the property of the current synthetic brake shoes with high friction factor both at home and abroad.
在充分剖析目前国內外高摩擦系数合成闸瓦性能的基础上,以酚醛树脂、丁腈橡胶粉、石墨、钾长石粉、铝矾土、硫酸钡等为主要原材料,采用干法工艺,围绕降低成本、简化工艺、提高并稳定产品性能等方面开展研究。
2) Friction coefficient in high temperature
高温摩擦系数
3) friction coefficient
摩擦系数
1.
Study on the friction coefficient of PCBN compact based on cutting force;
基于切削力的PCBN复合片表面摩擦系数研究
2.
Research on new test method of friction coefficient in extrusion process;
挤压工艺的摩擦系数测定新方法研究
3.
On the friction coefficient of diffusion coefficient model;
基于摩擦系数的扩散模型
4) Friction factor
摩擦系数
1.
Research on determining friction factor in column compression by meshless method;
无网格法标定圆柱体压缩过程摩擦系数研究
2.
Study on Workpiece vs Mandrel Velocity and Friction Factor Relationship of Fully-floating Mandrel Mill(Part I);
全浮动芯棒连轧管机组轧件与芯棒速度及摩擦系数研究(上)
3.
A study on lowering friction factor of rubber materials by acid treatment;
酸处理法降低橡胶材料摩擦系数的研究
5) frictional coefficient
摩擦系数
1.
Experimental testing is used to measure the dynamic frictional coefficient of the brake-tile on the working condition of simulated promotion.
在模拟矿井提升的工况下,实验测量闸瓦的动摩擦系数。
2.
Tested the frictional coefficient of natural coloured cotton fibers,get that the frictional coefficient of natural coloured cotton is small.
测试了天然彩棉纤维的摩擦系数,得出天然彩棉纤维的摩擦系数较小的结论。
3.
How to measure the frictional coefficient between sheet blank and die quantificationally by experiments is still a problem for the research work on sheet metal forming.
板料成形研究中的一个难点是如何采用实验方法定量测定板料成形过程中板料与模具之间的摩擦系数。
6) coefficient of friction
摩擦系数
1.
Based on theoretical calculations and experiment,analyzes the sliding property,friction property of the friction hoist and elasticity dynamics property of the wire rope,and points out the method which can prevent the friction hoist transmission from failure,that is,to limit the tension ratio of the wire rope and use the liner of high performance and the coefficient of friction.
在理论计算和试验的基础上,对摩擦轮提升的滑动特性、摩擦特性、钢丝绳弹性动力学特性进行分析,给出了防止摩擦提升传动失效(打滑)方法—限制钢丝绳张力比、采用高性能和高摩擦系数的摩擦衬垫。
2.
The coefficient of friction of POSF is decreased speedily first and then increased smoothly.
考察了储存时间对聚烯烃热收缩薄膜 ( POSF)综合性能的影响 ,研究发现 ,随储存时间增加 ,( 1)POSF的热收缩速率 ( v SR)递减 ,但热收缩率 ( SR)基本不变 ;( 2 )摩擦系数 ( COF)历经迅速降低后缓慢增加 ,直至稳定。
3.
The effect of crystal plane selection of diamond cutting tools on cutting process and perfomance of cutting tools was studied from the viempints of coefficient of friction between diamnod too and work piece material, tool wear and micro-strength of the cutting edge.
本文从刀具与工件间的摩擦系数、刀具磨损及微观强度几个方面研究了金刚石刀具晶面选择对切削过程及刀具使用性能的影响研究结果表明，金刚石和工件间的摩擦系数存在明显的各向异性，沿不同晶面、不同晶向上的摩擦系数相差很大。
补充资料：摩擦系数
见摩擦。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条