1) binary particle system
双粒级复配
1.
A simple method has been proposed to predict the minimum fluidization velocity Umf from the pressure fluctuation of single and binary particle systems sieve-screened from silicon powders.
对双粒级复配混合颗粒体系的p进行的实验研究发现,其p介于相关单粒级体系的p之间,并且粗颗粒组份的比例对p的影响较大。
2) particle size distribution
颗粒级配
1.
Relationship between particle size distribution of phosphorous slagand strength of phosphorous slag cement;
磷渣颗粒级配与磷渣水泥强度的关系
2.
The influence of particle size distribution of mineral admixture on the properties of cement mortar;
矿物掺合料的颗粒级配对水泥砂浆性能的影响
3.
The influence of the particle size distribution of compound mineral admixture on strength and microstructure of cement mortar;
复合矿物掺合料颗粒级配对水泥砂浆强度及微观结构的影响
3) Particle gradation
粒度级配
1.
In the paper,the development in preparing ultrafine explosive at home and abroad is comprehensively analyzed,and a disquisitive content was set up by consulting the domestic and overseas correlative datum,that is NTO ultrafine and particle gradation with using supercritical CO2 anti-solvent.
本文的具体方案主要有两部分,即用GAS法超细化NTO及其粒度级配。
2.
The present development of the explosive of thinning and particle gradation both hereand abroad is summarized in the paper.
本论文综述了目前国内外关于炸药细化技术及粒度级配的研究进展。
4) particle grade
颗粒级配
1.
Studies on particle grade in the preparation of conductive composite bipolar plate;
导电复合材料双极板制备中的颗粒级配研究
2.
Influence of particle grade on the electrical conductivity and gas-tightness of graphite/polymer composite;
石墨颗粒级配对复合板导电及阻气性能的影响
3.
Research progress on particle grade of conductivity polymer blending with the carbonic filler;
高分子导电复合材料的颗粒级配技术研究进展
5) grain graduation
粒度级配
1.
In order to guarantee that the products of spinelbased inert anode possess high volume density and low porosity, based on the theory of ball arrangement and started with grain composition of the raw material, the grain graduation of spinel was studied experimentally.
实验中根据不同的产品规格,设定了4种不同的主颗粒,通过测量振实密度以寻求最佳的粒度级配。
6) size distribution
粒径级配
1.
The relationships among preparation parameters,including density of the green body and the size distribution of the raw materials,microstructure and the properties of the materials were revealed.
采用氮化硅作为碳化硅材料的结合相的方法制备氮化硅结合碳化硅耐火材料 ,通过对氮化硅结合碳化硅的生坯制备过程的探讨 ,分析了生坯密度、原料粒径级配及制备过程各工艺参数之间的关系 。
2.
The size distributions of eroded sediment,deposit and suspended sediment in the basin .
在此基础上,通过流域侵蚀、沉积物和悬移质泥沙粒径级配的对比分析,计算得出每年从长江上游侵蚀下来的泥沙中,粒径大于0。
补充资料：配成复混肥料(见复混肥料)
配成复混肥料(见复混肥料)
肥料。配成复混肥料见复混
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条