1) Colloid morphology
胶粒形貌
2) particle morphology
颗粒形貌
1.
Effect of particle morphology of basic magnesium carbonate on viscosity and curing time of epoxy resin;
碱式碳酸镁颗粒形貌对环氧树脂黏度和固化时间的影响
2.
The effect of particle morphology of α-Al_2O_3 on sintering property of its compact is investigated in this paper.
通过对α-Al2O3颗粒形貌及其烧结体断面显微结构的分析,以及坯体的线收缩率、密度和吸水率的测定,研究了α-Al2O3颗粒形貌对坯体烧结性能的影响。
3.
The particle morphology, the grain size distribution and the DTA curve were investigated and the corresponding effects on the quality of spraying coatings were discussed.
在SUS316L不锈钢基体上,采用HVOF和DGS两种不同的工艺方法,分别喷涂WC-12Co和FeAl涂层,观察WC-12Co和FeAl粉末的颗粒形貌、粒度组成以及DTA,研究它们对热喷涂涂层质量的影响。
3) granule appearance
颗粒形貌
1.
The granule appearance and digestion resistibility of native and microwave modified high amylose starch granules under different microwave conditions were investigated by SEM and in in vitro digestion model.
采用扫描电镜和生物体外(invitro)降解方法,对不同微波作用条件下的高链玉米淀粉的颗粒形貌和抗消化性能进行了研究。
2.
The granule appearance and crystal structure of hydroxylpropyl starch were studied at different molar substitution with scanning electron microscopy,X-ray diffraction andpolarizing microscopy.
本文应用扫描电镜、X-光衍射和偏光显微等现代分析技术，观察和研究了不同取代度羟丙基淀粉和原淀粉的颗粒形貌及其结晶结构。
4) granular appearance
颗粒形貌
1.
Effects of ultrasonic field on the granular appearance and crystallian structure of potato starch;
超声场对马铃薯淀粉颗粒形貌与结晶结构的影响
2.
The changes of granular appearance and crystal structure of starch after being kneaded were investigated by SEM, polarization microscope and X-ray diffractometry.
利用扫描电子显微、偏光显微、X-射线衍射等现代分析技术,研究了经捏合作用后淀粉颗粒形貌和结晶结构的变化。
5) particle shape
颗粒形貌
1.
Influence of particle shape of cement on its physical properties was studied by means of SEM and pore structure analysis.
以多组水泥样品为对象,在控制其颗粒级配、比表面积基本一致的条件下,利用扫描电镜等测试手段,研究水泥颗粒形貌改善对水泥性能及孔结构等的影响。
6) grain shape
颗粒形貌
1.
The grain shape were studied by the composition conditions.
溶液/油相比较小时,样品颗粒呈球形;溶液/油相比较高时,颗粒形貌呈棒状。
补充资料：胶粒
分子式：
CAS号：
性质： 形成胶体溶液的分子或分子聚集体。其平均直径在1nm至1μtm之间。胶粒的形状很复杂，最简单的情形是球形质点，一般以质点直径的平均值或分子量的平均值来表示其大小。
CAS号：
性质： 形成胶体溶液的分子或分子聚集体。其平均直径在1nm至1μtm之间。胶粒的形状很复杂，最简单的情形是球形质点，一般以质点直径的平均值或分子量的平均值来表示其大小。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条